English
Немецкий
Арабский язык
Французский
Индонезийский
Японский язык
Корейский
Японский
Португальский
Русский языкТекущий
Испанский язык
Тайский
Турецкий
Вьетнамский язык
Аксессуары для установки в чистых помещениях
Стенный рукава для чистых помещений
A double-flange stainless steel sleeve that forms a smooth, durable passage through cleanroom wall panels for pipes and services.
- Smooth Hollow Bore
- Double Hygienic Flange
- 304 Stainless Steel
- Panel-Edge Protection
Введение продукции
The cleanroom wall sleeve is a rigid stainless tube with broad circular trim flanges at both ends. Installed through a prepared panel opening, it protects the exposed panel core and creates a smooth bore for routing a process pipe, conduit or service line. Continuous welded transitions and brushed surfaces simplify perimeter sealing and wipe-down on both room faces.
Основные характеристики
Two broad flanges cover the cut edges on both sides of the partition.
Smooth welded tube-to-flange transitions reduce dirt-catching ledges.
Sleeve diameter and barrel length can be matched to the service and panel thickness.
Обеспокоенность клиентов продуктами
A raw hole through an insulated cleanroom panel exposes core material and leaves an irregular perimeter that is difficult to seal and clean.
Cut panel edges release debris or absorb moisture around the penetration.The continuous metal barrel isolates the panel core from the service passage.
Irregular openings leave visible gaps around the pipe route.Broad end flanges cover the cut perimeter and provide consistent sealing faces.
Sharp panel skins can damage cables or small tubing.The smooth finished bore removes exposed sheet-metal edges from the passage.
Fixed stock lengths do not match different wall build-ups.Sleeve length is produced to suit the panel thickness and finish allowance.
Типичные приложения
Process-pipe wall passagesClean utility conduitsElectrical service penetrationsInstrument tubing routesHygienic panel openings
Технические параметры
Typical construction ranges for a double-flange stainless cleanroom wall sleeve are listed below.
| Основной материал | 304 or 316L stainless-steel tubular sleeve with welded circular flanges |
|---|---|
| Толщина панели | 40-200 mm compatible partition thickness |
| эффективная ширина | 25-300 mm clear internal bore diameter |
| Максимальная длина | Up to 1000 mm sleeve barrel length |
| Толщина линий стали | 1.00-3.00 mm tube wall and flange fabrication thickness |
| Плотность ядра | Approximately 7900-8000 kg/m³ for stainless steel |
| Теплопроводимость | Approximately 14-17 W/(m·K) for austenitic stainless steel |
| Поверхностная отделка | Brushed, satin-polished or electropolished stainless-steel surfaces |
| Объединенный тип | Through-panel sleeve with welded double trim flanges and sealed perimeter |
| Customization | Доступно в зависимости от предполагаемого применения и операционной среды. |
Доступные варианты
304 or 316L stainless steelCustom bore diameterFixed or split trim flangeBrushed or electropolished finish
Planning a Cleanroom Wall Sleeve specification?
Отправьте нам ваши габариты, условия монтажа, целевые показатели производительности и требуемую отделку поверхности.
