Three-quarter view of a double-flange stainless cleanroom wall sleeve

Aksesori Pemasangan Bilik Bersih

Lengan Dinding Bilik Bersih

A double-flange stainless steel sleeve that forms a smooth, durable passage through cleanroom wall panels for pipes and services.

Smooth Hollow Bore
Double Hygienic Flange
304 Stainless Steel
Panel-Edge Protection

Permintaan sebut harga Semak imbas produk

Pengenalan Produk

The cleanroom wall sleeve is a rigid stainless tube with broad circular trim flanges at both ends. Installed through a prepared panel opening, it protects the exposed panel core and creates a smooth bore for routing a process pipe, conduit or service line. Continuous welded transitions and brushed surfaces simplify perimeter sealing and wipe-down on both room faces.

Ciri-ciri Utama

A continuous stainless bore isolates the service opening from the exposed panel core.

Two broad flanges cover the cut edges on both sides of the partition.

Smooth welded tube-to-flange transitions reduce dirt-catching ledges.

Sleeve diameter and barrel length can be matched to the service and panel thickness.

Kebimbangan Produk Pelanggan

A raw hole through an insulated cleanroom panel exposes core material and leaves an irregular perimeter that is difficult to seal and clean.

Cut panel edges release debris or absorb moisture around the penetration.The continuous metal barrel isolates the panel core from the service passage.

Irregular openings leave visible gaps around the pipe route.Broad end flanges cover the cut perimeter and provide consistent sealing faces.

Sharp panel skins can damage cables or small tubing.The smooth finished bore removes exposed sheet-metal edges from the passage.

Fixed stock lengths do not match different wall build-ups.Sleeve length is produced to suit the panel thickness and finish allowance.

Permohonan yang biasa

Process-pipe wall passagesClean utility conduitsElectrical service penetrationsInstrument tubing routesHygienic panel openings

Parameter teknikal

Typical construction ranges for a double-flange stainless cleanroom wall sleeve are listed below.

Bahan Teras	304 or 316L stainless-steel tubular sleeve with welded circular flanges
Ketebalan Panel	40-200 mm compatible partition thickness
Lebar berkesan	25-300 mm clear internal bore diameter
Panjang maksimum	Up to 1000 mm sleeve barrel length
Keluli Menghadapi Ketebalan	1.00-3.00 mm tube wall and flange fabrication thickness
Ketumpatan teras	Approximately 7900-8000 kg/m³ for stainless steel
Kekonduksian Terma	Approximately 14-17 W/(m·K) for austenitic stainless steel
Kemasan permukaan	Brushed, satin-polished or electropolished stainless-steel surfaces
Jenis Bersatu	Through-panel sleeve with welded double trim flanges and sealed perimeter
Penyesuaian	Boleh didapati berdasarkan aplikasi yang dimaksudkan dan persekitaran operasi.

Pilihan yang boleh didapati

304 or 316L stainless steelCustom bore diameterFixed or split trim flangeBrushed or electropolished finish

Planning a Cleanroom Wall Sleeve specification?

Hantarkan kepada kami dimensi anda, syarat pemasangan, sasaran prestasi dan kemasan permukaan yang diperlukan.

Berbincang dengan pasukan kami