English
الألمانية
العربيةالحالي
الفرنسية
الإندونيسية
اليابانية
الكورية
اللغة الملاوية
البرتغالية
الروسية
الإسبانية
التايلاندية
اللغة التركية
اللغة الفيتنامية
اكسسوارات تركيب الغرف النظيفة
غرفة نظيفة الجدار كم
A double-flange stainless steel sleeve that forms a smooth, durable passage through cleanroom wall panels for pipes and services.
- Smooth Hollow Bore
- Double Hygienic Flange
- 304 Stainless Steel
- Panel-Edge Protection
مقدمة المنتج
The cleanroom wall sleeve is a rigid stainless tube with broad circular trim flanges at both ends. Installed through a prepared panel opening, it protects the exposed panel core and creates a smooth bore for routing a process pipe, conduit or service line. Continuous welded transitions and brushed surfaces simplify perimeter sealing and wipe-down on both room faces.
الخصائص الرئيسية
Two broad flanges cover the cut edges on both sides of the partition.
Smooth welded tube-to-flange transitions reduce dirt-catching ledges.
Sleeve diameter and barrel length can be matched to the service and panel thickness.
مخاوف المنتج للعملاء
A raw hole through an insulated cleanroom panel exposes core material and leaves an irregular perimeter that is difficult to seal and clean.
Cut panel edges release debris or absorb moisture around the penetration.The continuous metal barrel isolates the panel core from the service passage.
Irregular openings leave visible gaps around the pipe route.Broad end flanges cover the cut perimeter and provide consistent sealing faces.
Sharp panel skins can damage cables or small tubing.The smooth finished bore removes exposed sheet-metal edges from the passage.
Fixed stock lengths do not match different wall build-ups.Sleeve length is produced to suit the panel thickness and finish allowance.
تطبيقات نموذجية
Process-pipe wall passagesClean utility conduitsElectrical service penetrationsInstrument tubing routesHygienic panel openings
المعلمات الفنية
Typical construction ranges for a double-flange stainless cleanroom wall sleeve are listed below.
| المواد الأساسية | 304 or 316L stainless-steel tubular sleeve with welded circular flanges |
|---|---|
| سمك اللوحة | 40-200 mm compatible partition thickness |
| العرض الفعال | 25-300 mm clear internal bore diameter |
| الحد الأقصى الطول | Up to 1000 mm sleeve barrel length |
| الصلب يواجه سمك | 1.00-3.00 mm tube wall and flange fabrication thickness |
| الكثافة الأساسية | Approximately 7900-8000 kg/m³ for stainless steel |
| الموصلية الحرارية | Approximately 14-17 W/(m·K) for austenitic stainless steel |
| إنهاء السطح | Brushed, satin-polished or electropolished stainless-steel surfaces |
| نوع المشترك | Through-panel sleeve with welded double trim flanges and sealed perimeter |
| التخصيص | متوفر على أساس التطبيق المقصود وبيئة التشغيل. |
الخيارات المتاحة
304 or 316L stainless steelCustom bore diameterFixed or split trim flangeBrushed or electropolished finish
Planning a Cleanroom Wall Sleeve specification?
أرسل لنا الأبعاد الخاصة بك، شروط التثبيت، أهداف الأداء والتشطيب السطحي المطلوب.
