Inglês
Alemão
Língua árabe
Francês
Língua indonésia
Japonês
Coreano
Língua malaia
Portuguêsatual
Língua russa
Espanhol
Tailandês
Língua turca
Vietnã
Portas de sala limpa, janelas e sistemas de bloqueio
Airtight Cleanroom Door Gasket (em inglês)
A smooth resilient perimeter seal that compresses between the cleanroom door leaf and frame to limit uncontrolled air leakage.
- Seal de perímetro contínuo
- Low Compression Set
- Replaceable Profile
- Smooth Cleanable Surface
Introdução do produto
The airtight cleanroom door gasket is extruded from silicone or EPDM into a hollow bulb, blade or multi-lip profile sized to the door-frame groove. Controlled compression closes small installation tolerances around the jamb and head while allowing the leaf to operate without excessive force. A clip-in, channel-retained or bonded base keeps the exposed seal continuous and permits replacement when the compression profile eventually wears.
Características-chave
Smooth non-porous surfaces support regular wipe-down without exposed fibres.
Moulded or bonded corner joints preserve continuity around rectangular door openings.
Replaceable channel-retained profiles reduce downtime when the sealing lip is damaged.
Preocupações do produto do cliente
Perimeter leakage often occurs at corners and variable frame gaps rather than across the center of the door leaf.
A hard seal increases closing force and prevents the latch from seating consistently.The hollow gasket profile compresses at a controlled load across the designed gap.
Cut corners separate over time and create direct leakage paths.Continuous extrusions are joined with moulded or vulcanized corner connections.
A permanently bonded gasket is difficult to replace after mechanical damage.Clip-in and channel-retained bases allow the worn profile to be removed independently.
Aplicações típicas
Cleanroom door perimetersBio-containment room entrancesLaboratory airlocksControlled-temperature clean spaces
Parâmetros técnicos
Representative material and profile ranges for an airtight cleanroom perimeter gasket are listed below.
| Material principal | Closed-cell silicone, solid silicone or EPDM elastomer |
|---|---|
| Painel de espessura | Approximately 6–15 mm compressed profile thickness |
| Largura efetiva | Approximately 12–30 mm sealing-face width |
| Comprimento máximo | Up to 6000 mm continuous coil length before corner joining |
| Aço enfrentando espessura | 0.8–1.0 mm stainless-steel retainer where a metal carrier is selected |
| Densidade Core | Approximately 500–1300 kg/m³ depending on cellular or solid elastomer |
| Condutividade térmica | Approximately 0.15–0.30 W/(m·K) for silicone or EPDM material |
| Superfície acabado | Smooth non-porous black, gray, white or translucent elastomer surface |
| Tipo conjunto | Clip-in, channel-retained or bonded perimeter profile with sealed corner joints |
| Customização | Disponível com base na aplicação pretendida e no ambiente operacional. |
Opções disponíveis
Silicone or EPDM compoundBulb, blade or multi-lip profileBlack, gray, white or translucent colorMoulded corner and stainless carrier sets
Planning a Airtight Cleanroom Door Gasket specification?
Envie-nos as suas dimensões, condições de instalação, metas de desempenho e acabamento de superfície necessário.
