Airtight cleanroom door gasket profiles with stainless retaining channel

クリーンルームのドア、窓およびインターロックシステム

空気密閉クリーンルームのドアのガスケット

A smooth resilient perimeter seal that compresses between the cleanroom door leaf and frame to limit uncontrolled air leakage.

Continuous Perimeter Seal
Low Compression Set
Replaceable Profile
Smooth Cleanable Surface

見積もりリクエスト製品案内

商品紹介

The airtight cleanroom door gasket is extruded from silicone or EPDM into a hollow bulb, blade or multi-lip profile sized to the door-frame groove. Controlled compression closes small installation tolerances around the jamb and head while allowing the leaf to operate without excessive force. A clip-in, channel-retained or bonded base keeps the exposed seal continuous and permits replacement when the compression profile eventually wears.

主要な特徴

A hollow resilient section accommodates small variations in the leaf-to-frame gap.

Smooth non-porous surfaces support regular wipe-down without exposed fibres.

Moulded or bonded corner joints preserve continuity around rectangular door openings.

Replaceable channel-retained profiles reduce downtime when the sealing lip is damaged.

お客様の製品に関する懸念事項

Perimeter leakage often occurs at corners and variable frame gaps rather than across the center of the door leaf.

A hard seal increases closing force and prevents the latch from seating consistently.The hollow gasket profile compresses at a controlled load across the designed gap.

Cut corners separate over time and create direct leakage paths.Continuous extrusions are joined with moulded or vulcanized corner connections.

A permanently bonded gasket is difficult to replace after mechanical damage.Clip-in and channel-retained bases allow the worn profile to be removed independently.

典型的な用途

Cleanroom door perimetersBio-containment room entrancesLaboratory airlocksControlled-temperature clean spaces

技術的なパラメータ

Representative material and profile ranges for an airtight cleanroom perimeter gasket are listed below.

コア材料	Closed-cell silicone, solid silicone or EPDM elastomer
パネルの厚さ	Approximately 6–15 mm compressed profile thickness
有効幅	Approximately 12–30 mm sealing-face width
最大長さ	Up to 6000 mm continuous coil length before corner joining
鋼鉄の厚さを直面する	0.8–1.0 mm stainless-steel retainer where a metal carrier is selected
コア密度	Approximately 500–1300 kg/m³ depending on cellular or solid elastomer
熱伝導率	Approximately 0.15–0.30 W/(m·K) for silicone or EPDM material
表面仕上げ	Smooth non-porous black, gray, white or translucent elastomer surface
ジョイントタイプ	Clip-in, channel-retained or bonded perimeter profile with sealed corner joints
カスタマイズ	意図したアプリケーションと動作環境に基づいて利用できます。

利用可能なオプション

Silicone or EPDM compoundBulb, blade or multi-lip profileBlack, gray, white or translucent colorMoulded corner and stainless carrier sets

Planning a Airtight Cleanroom Door Gasket specification?

寸法、設置条件、性能目標、必要な表面仕上げをお送りください。

チームに相談する