Anglais
Allemand
Arabe
FrançaisCurrent
Indonésien
Japonais
Coréen
Le malais
Le portugais
russe
espagnol
Thaïlandais
Le turc
Le vietnamien
Portes de salle blanche, fenêtres et systèmes de verrouillage
Aétanchéité à la porte de la salle blanche
A smooth resilient perimeter seal that compresses between the cleanroom door leaf and frame to limit uncontrolled air leakage.
- Continuous Perimeter Seal
- Low Compression Set
- Replaceable Profile
- Smooth Cleanable Surface
Introduction de produit
The airtight cleanroom door gasket is extruded from silicone or EPDM into a hollow bulb, blade or multi-lip profile sized to the door-frame groove. Controlled compression closes small installation tolerances around the jamb and head while allowing the leaf to operate without excessive force. A clip-in, channel-retained or bonded base keeps the exposed seal continuous and permits replacement when the compression profile eventually wears.
Key Features
Smooth non-porous surfaces support regular wipe-down without exposed fibres.
Moulded or bonded corner joints preserve continuity around rectangular door openings.
Replaceable channel-retained profiles reduce downtime when the sealing lip is damaged.
Préoccupations du client produit
Perimeter leakage often occurs at corners and variable frame gaps rather than across the center of the door leaf.
A hard seal increases closing force and prevents the latch from seating consistently.The hollow gasket profile compresses at a controlled load across the designed gap.
Cut corners separate over time and create direct leakage paths.Continuous extrusions are joined with moulded or vulcanized corner connections.
A permanently bonded gasket is difficult to replace after mechanical damage.Clip-in and channel-retained bases allow the worn profile to be removed independently.
Les applications typiques
Cleanroom door perimetersBio-containment room entrancesLaboratory airlocksControlled-temperature clean spaces
Paramètres techniques
Representative material and profile ranges for an airtight cleanroom perimeter gasket are listed below.
| Matériaux de base | Closed-cell silicone, solid silicone or EPDM elastomer |
|---|---|
| Panneau épaisseur | Approximately 6–15 mm compressed profile thickness |
| Largeur effective | Approximately 12–30 mm sealing-face width |
| Longueur maximale | Up to 6000 mm continuous coil length before corner joining |
| Acier face épaisseur | 0.8–1.0 mm stainless-steel retainer where a metal carrier is selected |
| Densité Core | Approximately 500–1300 kg/m³ depending on cellular or solid elastomer |
| Conductivité thermique | Approximately 0.15–0.30 W/(m·K) for silicone or EPDM material |
| surface finie | Smooth non-porous black, gray, white or translucent elastomer surface |
| Type joint | Clip-in, channel-retained or bonded perimeter profile with sealed corner joints |
| Customisation | Disponible en fonction de l'application prévue et de l'environnement d'exploitation. |
Options disponibles
Silicone or EPDM compoundBulb, blade or multi-lip profileBlack, gray, white or translucent colorMoulded corner and stainless carrier sets
Planning a Airtight Cleanroom Door Gasket specification?
Envoyez-nous vos dimensions, conditions d'installation, objectifs de performance et finition de surface requise.
