İngilizce
Almanca
Arapça
Fransızca
Endonezya dilinde
Japonca
Korece
Malay dilinde
Portekizce
Rusça
İspanyolca
Taylandca
TürkçeCurrent
Vietnamca
Temiz Oda Kapıları, Pencereler ve Kilitleme Sistemleri
Hava geçirmez temiz oda kapı gasket
A smooth resilient perimeter seal that compresses between the cleanroom door leaf and frame to limit uncontrolled air leakage.
- Continuous Perimeter Seal
- Low Compression Set
- Replaceable Profile
- Smooth Cleanable Surface
Ürün tanıtımı
The airtight cleanroom door gasket is extruded from silicone or EPDM into a hollow bulb, blade or multi-lip profile sized to the door-frame groove. Controlled compression closes small installation tolerances around the jamb and head while allowing the leaf to operate without excessive force. A clip-in, channel-retained or bonded base keeps the exposed seal continuous and permits replacement when the compression profile eventually wears.
Ana Özellikler
Smooth non-porous surfaces support regular wipe-down without exposed fibres.
Moulded or bonded corner joints preserve continuity around rectangular door openings.
Replaceable channel-retained profiles reduce downtime when the sealing lip is damaged.
Müşteri Ürün Sorunları
Perimeter leakage often occurs at corners and variable frame gaps rather than across the center of the door leaf.
A hard seal increases closing force and prevents the latch from seating consistently.The hollow gasket profile compresses at a controlled load across the designed gap.
Cut corners separate over time and create direct leakage paths.Continuous extrusions are joined with moulded or vulcanized corner connections.
A permanently bonded gasket is difficult to replace after mechanical damage.Clip-in and channel-retained bases allow the worn profile to be removed independently.
Tipik uygulamalar
Cleanroom door perimetersBio-containment room entrancesLaboratory airlocksControlled-temperature clean spaces
Teknik parametreler
Representative material and profile ranges for an airtight cleanroom perimeter gasket are listed below.
| Temel malzemeler | Closed-cell silicone, solid silicone or EPDM elastomer |
|---|---|
| Panel kalınlığı | Approximately 6–15 mm compressed profile thickness |
| Effective Width (Etkili Genişlik) | Approximately 12–30 mm sealing-face width |
| Maksimum uzunluk | Up to 6000 mm continuous coil length before corner joining |
| Çelik yüz yüze kalınlığı | 0.8–1.0 mm stainless-steel retainer where a metal carrier is selected |
| Core Density (Çekirdek Yoğunluğu) | Approximately 500–1300 kg/m³ depending on cellular or solid elastomer |
| Termal İletkenlik | Approximately 0.15–0.30 W/(m·K) for silicone or EPDM material |
| Yüzey bitirme | Smooth non-porous black, gray, white or translucent elastomer surface |
| Ortak tip | Clip-in, channel-retained or bonded perimeter profile with sealed corner joints |
| Customization (Özelleşme) | Kullanılan uygulama ve çalışma ortamına göre kullanılabilir. |
Mevcut Seçenekler
Silicone or EPDM compoundBulb, blade or multi-lip profileBlack, gray, white or translucent colorMoulded corner and stainless carrier sets
Planning a Airtight Cleanroom Door Gasket specification?
Bize boyutlarınızı, montaj koşullarınızı, performans hedeflerinizi ve gerekli yüzey kaplamalarınızı gönderin.
