Airtight cleanroom door gasket profiles with stainless retaining channel

클린룸 도어, 창문 및 인터락 시스템

공기 밀봉 클린룸 도어 가스켓

A smooth resilient perimeter seal that compresses between the cleanroom door leaf and frame to limit uncontrolled air leakage.

Continuous Perimeter Seal
Low Compression Set
Replaceable Profile
Smooth Cleanable Surface

견적 요청 제품 찾아보기

상품 소개

The airtight cleanroom door gasket is extruded from silicone or EPDM into a hollow bulb, blade or multi-lip profile sized to the door-frame groove. Controlled compression closes small installation tolerances around the jamb and head while allowing the leaf to operate without excessive force. A clip-in, channel-retained or bonded base keeps the exposed seal continuous and permits replacement when the compression profile eventually wears.

주요 기능

A hollow resilient section accommodates small variations in the leaf-to-frame gap.

Smooth non-porous surfaces support regular wipe-down without exposed fibres.

Moulded or bonded corner joints preserve continuity around rectangular door openings.

Replaceable channel-retained profiles reduce downtime when the sealing lip is damaged.

고객 제품 관심사

Perimeter leakage often occurs at corners and variable frame gaps rather than across the center of the door leaf.

A hard seal increases closing force and prevents the latch from seating consistently.The hollow gasket profile compresses at a controlled load across the designed gap.

Cut corners separate over time and create direct leakage paths.Continuous extrusions are joined with moulded or vulcanized corner connections.

A permanently bonded gasket is difficult to replace after mechanical damage.Clip-in and channel-retained bases allow the worn profile to be removed independently.

일반적인 응용 프로그램

Cleanroom door perimetersBio-containment room entrancesLaboratory airlocksControlled-temperature clean spaces

기술 매개변수

Representative material and profile ranges for an airtight cleanroom perimeter gasket are listed below.

핵심 재료	Closed-cell silicone, solid silicone or EPDM elastomer
패널 두께	Approximately 6–15 mm compressed profile thickness
유효 폭	Approximately 12–30 mm sealing-face width
최대 길이	Up to 6000 mm continuous coil length before corner joining
강철 면면 두께	0.8–1.0 mm stainless-steel retainer where a metal carrier is selected
코어 밀도	Approximately 500–1300 kg/m³ depending on cellular or solid elastomer
열전도도 (Thermal Conductivity)	Approximately 0.15–0.30 W/(m·K) for silicone or EPDM material
표면 마무리	Smooth non-porous black, gray, white or translucent elastomer surface
접합 유형	Clip-in, channel-retained or bonded perimeter profile with sealed corner joints
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

사용 가능한 옵션

Silicone or EPDM compoundBulb, blade or multi-lip profileBlack, gray, white or translucent colorMoulded corner and stainless carrier sets

Planning a Airtight Cleanroom Door Gasket specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.