Airtight cleanroom door gasket profiles with stainless retaining channel

Pintu Cleanroom, Jendela dan Sistem Interlock

Gasket Pintu Cleanroom Airtight

A smooth resilient perimeter seal that compresses between the cleanroom door leaf and frame to limit uncontrolled air leakage.

Continuous Perimeter Seal
Low Compression Set
Replaceable Profile
Smooth Cleanable Surface

Permintaan untuk kutipan Browse Produk

Perkenalan produk

The airtight cleanroom door gasket is extruded from silicone or EPDM into a hollow bulb, blade or multi-lip profile sized to the door-frame groove. Controlled compression closes small installation tolerances around the jamb and head while allowing the leaf to operate without excessive force. A clip-in, channel-retained or bonded base keeps the exposed seal continuous and permits replacement when the compression profile eventually wears.

Fitur utama:

A hollow resilient section accommodates small variations in the leaf-to-frame gap.

Smooth non-porous surfaces support regular wipe-down without exposed fibres.

Moulded or bonded corner joints preserve continuity around rectangular door openings.

Replaceable channel-retained profiles reduce downtime when the sealing lip is damaged.

Kekhawatiran produk pelanggan

Perimeter leakage often occurs at corners and variable frame gaps rather than across the center of the door leaf.

A hard seal increases closing force and prevents the latch from seating consistently.The hollow gasket profile compresses at a controlled load across the designed gap.

Cut corners separate over time and create direct leakage paths.Continuous extrusions are joined with moulded or vulcanized corner connections.

A permanently bonded gasket is difficult to replace after mechanical damage.Clip-in and channel-retained bases allow the worn profile to be removed independently.

Aplikasi yang Tipis

Cleanroom door perimetersBio-containment room entrancesLaboratory airlocksControlled-temperature clean spaces

Parameter teknis

Representative material and profile ranges for an airtight cleanroom perimeter gasket are listed below.

Bahan inti	Closed-cell silicone, solid silicone or EPDM elastomer
Ketebalan Panel (Panel Thickness)	Approximately 6–15 mm compressed profile thickness
Efektif lebar	Approximately 12–30 mm sealing-face width
Panjang maksimum	Up to 6000 mm continuous coil length before corner joining
Baja menghadap ketebalan	0.8–1.0 mm stainless-steel retainer where a metal carrier is selected
Kepadatan inti (core density)	Approximately 500–1300 kg/m³ depending on cellular or solid elastomer
Konduktivitas Termal (Thermal Conductivity)	Approximately 0.15–0.30 W/(m·K) for silicone or EPDM material
Permukaan selesai	Smooth non-porous black, gray, white or translucent elastomer surface
Jenis Bersama	Clip-in, channel-retained or bonded perimeter profile with sealed corner joints
Customization (Kustomisasi)	Tersedia berdasarkan aplikasi yang dimaksudkan dan lingkungan operasi.

Pilihan yang tersedia

Silicone or EPDM compoundBulb, blade or multi-lip profileBlack, gray, white or translucent colorMoulded corner and stainless carrier sets

Planning a Airtight Cleanroom Door Gasket specification?

Kirimkan kami dimensi Anda, kondisi instalasi, target kinerja dan permukaan akhir yang diperlukan.

Bicaralah dengan tim kami