Stainless steel cleanroom cable tray with complete covered straight section

Pencahayaan bilik bersih dan peralatan elektrik

Dulang kabel keluli tahan karat

A corrosion-resistant stainless cable-support system for wet, chemical-cleaning or hygienic cleanroom service routes.

SUS304 or SUS316L
Pickled and Passivated Finish
Deburred Hygienic Edges
Corrosion-Resistant Fittings

Permintaan sebut harga Semak imbas produk

Pengenalan Produk

The stainless cable tray is formed from 304 or 316L sheet, wire or ladder components and then cleaned, pickled and passivated to restore a uniform protective surface. Smooth bends, stainless splice hardware and compatible supports prevent mixed-metal corrosion. Solid covers are available where the route is visible in the cleanroom, while ventilated or wire profiles can be used in service voids where heat dissipation is more important.

Ciri-ciri Utama

316L material provides improved resistance where chloride-bearing cleaners are present.

Pickling removes fabrication scale and passivation restores the protective surface film.

Deburred edges protect both cable jackets and cleaning gloves.

Stainless fasteners avoid dissimilar-metal staining at tray joints.

Matching covers and fittings maintain one material system through the route.

Kebimbangan Produk Pelanggan

Stainless tray performance depends on grade, fabrication finish and compatible joint hardware rather than material name alone.

Carbon-steel cut edges rust after repeated chemical cleaning.Stainless construction and post-fabrication passivation remove exposed ferrous coating breaks.

Mixed plated hardware produces rust streaks at joints.Matched stainless bolts, washers and supports maintain material compatibility.

Burrs cut cable jackets during installation.Rounded and mechanically deburred edges protect pulled conductors.

Open tray contents create a visible dust shelf.A fitted stainless cover closes exposed runs while remaining removable.

Permohonan yang biasa

Pharmaceutical washdown areasClean utility plantsFood and biotechnology facilitiesCorrosive laboratory services

Parameter teknikal

Typical configurable construction ranges for a stainless steel cable tray are listed below.

Bahan Teras	SUS304 or SUS316L sheet, wire or ladder tray with matching stainless covers, fittings and fasteners
Ketebalan Panel	50-150 mm tray side-wall or ladder depth
Lebar berkesan	100-900 mm usable tray width
Panjang maksimum	Up to 3000 mm per straight section
Keluli Menghadapi Ketebalan	1.0-2.5 mm stainless tray and cover thickness
Ketumpatan teras	Approximately 7900-8000 kg/m³ for austenitic stainless steel
Kekonduksian Terma	14-16 W/(m·K) for SUS304/SUS316L material
Kemasan permukaan	Pickled and passivated matte stainless, or fine-brushed sanitary finish
Jenis Bersatu	Bolted stainless splice plates with matched bends, support brackets and removable cover
Penyesuaian	Boleh didapati berdasarkan aplikasi yang dimaksudkan dan persekitaran operasi.

Pilihan yang boleh didapati

SUS304 or SUS316L gradeSolid, perforated, wire or ladder profileOpen or covered constructionCustom support spacing and fittings

Planning a Stainless Steel Cable Tray specification?

Hantarkan kepada kami dimensi anda, syarat pemasangan, sasaran prestasi dan kemasan permukaan yang diperlukan.

Berbincang dengan pasukan kami