English
الألمانية
العربيةالحالي
الفرنسية
الإندونيسية
اليابانية
الكورية
اللغة الملاوية
البرتغالية
الروسية
الإسبانية
التايلاندية
اللغة التركية
اللغة الفيتنامية
إضاءة الغرف النظيفة والمعدات الكهربائية
غرفة نظيفة علبة كابلات
A smooth cable-support system with rounded edges and cleanable covers for segregated routing above or within controlled spaces.
- Smooth Rounded Tray Profile
- Removable Cleanable Covers
- Power and Signal Segregation
- Matched Bends and Tees
مقدمة المنتج
Cleanroom cable tray uses a solid-bottom or limited-slot metal channel rather than an open industrial ladder inside exposed controlled areas. Snap-on or tool-retained covers shield cables from fallout and present a smooth upper face. Factory bends, tees, reducers and dividers maintain consistent edge radii and route segregation across changes in direction.
الخصائص الرئيسية
Continuous covers prevent loose cables from becoming a horizontal dust shelf.
Internal dividers separate power, data and instrumentation routes.
Matched fittings preserve cable bend radius at corners and branches.
Suspension brackets position the tray with access for cleaning around it.
مخاوف المنتج للعملاء
Exposed cables and conventional perforated trays create irregular surfaces that are difficult to wipe and easy to overfill.
Loose cable bundles collect dust and obstruct ceiling cleaning.A covered tray contains the route behind a continuous smooth surface.
Sharp cut edges abrade insulation during cable pulling.Rolled rims and factory fittings maintain smooth contact surfaces.
Power and sensor cables share one congested channel.Removable metal dividers preserve planned segregation.
Site-made corner cuts leave gaps and exposed fasteners.Matched bends, tees and reducers complete each directional change.
تطبيقات نموذجية
Cleanroom ceiling servicesEquipment power distributionControl and instrumentation routingLaboratory utility corridors
المعلمات الفنية
Typical configurable construction ranges for a cleanroom cable tray are listed below.
| المواد الأساسية | Powder-coated galvanized steel or aluminum solid-bottom tray with matching covers, dividers and fittings |
|---|---|
| سمك اللوحة | 50-150 mm tray side-wall height |
| العرض الفعال | 100-600 mm internal cable width |
| الحد الأقصى الطول | Up to 3000 mm per straight tray section |
| الصلب يواجه سمك | 1.0-2.0 mm tray and cover sheet thickness |
| الكثافة الأساسية | Approximately 7850 kg/m³ for galvanized steel tray material |
| الموصلية الحرارية | 45-60 W/(m·K) for the steel tray body |
| إنهاء السطح | Smooth white powder coat or zinc-coated finish with deburred rolled edges |
| نوع المشترك | Bolted splice plates with snap-on or retained cover, formed bends and removable internal divider |
| التخصيص | متوفر على أساس التطبيق المقصود وبيئة التشغيل. |
الخيارات المتاحة
Solid or limited-perforation bottomWhite coated steel or aluminumInternal segregation dividersStraight, bend, tee and reducer fittings
Planning a Cleanroom Cable Tray specification?
أرسل لنا الأبعاد الخاصة بك، شروط التثبيت، أهداف الأداء والتشطيب السطحي المطلوب.
