Complete cleanroom temperature and humidity control panel with color HMI and white room transmitter

Системы контроля за чистыми помещениями и экологического мониторинга

Система контроля температуры и влажности

A precision environmental controller that coordinates room sensing, cooling, reheating, humidification and dehumidification without allowing the loops to oppose one another.

Coordinated Temperature and RH
High-Stability Room Sensing
Heating and Cooling Sequencing
Humidity Limit Protection

Запрос котировки Просмотреть продукты

Введение продукции

The temperature and humidity control system uses stable room transmitters and sequenced HVAC outputs to maintain two strongly coupled variables. Cooling capacity can remove sensible and latent load, while reheating restores supply-air temperature after dehumidification. Humidifier commands are limited when duct or room conditions could create condensation. Separate occupied, setback and recovery modes allow the cleanroom to reach operating conditions predictably without excessive simultaneous heating and cooling.

Основные характеристики

Matched temperature and humidity sensing reduces drift between room display and control input.

Sequenced outputs prevent humidification and dehumidification from running against each other.

Dew-point and high-limit logic protects ductwork from unwanted moisture accumulation.

Trendable setpoints, outputs and alarms make slow environmental drift easier to diagnose.

Обеспокоенность клиентов продуктами

Temperature and relative humidity interact through cooling, reheating and process moisture, so independent loops often waste energy or oscillate.

Cooling lowers temperature but leaves relative humidity unstable after reheating.A coordinated sequence manages cooling, reheat and moisture removal as one control strategy.

Room sensors drift and create disagreement between control and monitoring values.Stable matched transmitters with accessible calibration points keep the control reference consistent.

Humidifier output causes condensation in cooler duct sections.Dew-point and duct high-limit signals clamp humidifier demand before moisture deposits.

The room takes too long to recover after a production shutdown.A dedicated recovery mode applies controlled maximum outputs until both variables enter their operating bands.

Типичные приложения

Pharmaceutical processing roomsMedical-device production roomsPrecision electronics productionControlled stability laboratories

Технические параметры

Typical construction for a cleanroom temperature and humidity control panel with room transmitter is listed below.

Основной материал	Powder-coated steel control enclosure with FR-4 controller board and polymer room transmitter
Толщина панели	160-300 mm enclosure depth
эффективная ширина	400-800 mm panel width
Максимальная длина	Up to 1200 mm panel height
Толщина линий стали	1.2-1.5 mm powder-coated steel enclosure
Плотность ядра	7800-8050 kg/m³ for steel panel components
Теплопроводимость	45-60 W/(m·K) for the steel enclosure
Поверхностная отделка	Fine-textured light-gray powder coat with white room sensor and color HMI
Объединенный тип	DIN-rail control panel with removable HVAC output terminals and network connection
Customization	Доступно в зависимости от предполагаемого применения и операционной среды.

Доступные варианты

Cooling and reheat stagesSteam or ultrasonic humidifier outputDew-point high limitRemote room transmitter

Planning a Temperature and Humidity Control System specification?

Отправьте нам ваши габариты, условия монтажа, целевые показатели производительности и требуемую отделку поверхности.

Поговорите с нашей командой