Complete cleanroom temperature and humidity control panel with color HMI and white room transmitter

クリーンルーム管理 · 環境モニタリングシステム

温度および湿度制御システム

A precision environmental controller that coordinates room sensing, cooling, reheating, humidification and dehumidification without allowing the loops to oppose one another.

Coordinated Temperature and RH
High-Stability Room Sensing
Heating and Cooling Sequencing
Humidity Limit Protection

見積もりリクエスト製品案内

商品紹介

The temperature and humidity control system uses stable room transmitters and sequenced HVAC outputs to maintain two strongly coupled variables. Cooling capacity can remove sensible and latent load, while reheating restores supply-air temperature after dehumidification. Humidifier commands are limited when duct or room conditions could create condensation. Separate occupied, setback and recovery modes allow the cleanroom to reach operating conditions predictably without excessive simultaneous heating and cooling.

主要な特徴

Matched temperature and humidity sensing reduces drift between room display and control input.

Sequenced outputs prevent humidification and dehumidification from running against each other.

Dew-point and high-limit logic protects ductwork from unwanted moisture accumulation.

Trendable setpoints, outputs and alarms make slow environmental drift easier to diagnose.

お客様の製品に関する懸念事項

Temperature and relative humidity interact through cooling, reheating and process moisture, so independent loops often waste energy or oscillate.

Cooling lowers temperature but leaves relative humidity unstable after reheating.A coordinated sequence manages cooling, reheat and moisture removal as one control strategy.

Room sensors drift and create disagreement between control and monitoring values.Stable matched transmitters with accessible calibration points keep the control reference consistent.

Humidifier output causes condensation in cooler duct sections.Dew-point and duct high-limit signals clamp humidifier demand before moisture deposits.

The room takes too long to recover after a production shutdown.A dedicated recovery mode applies controlled maximum outputs until both variables enter their operating bands.

典型的な用途

医薬品加工室Medical-device production roomsPrecision electronics productionControlled stability laboratories

技術的なパラメータ

Typical construction for a cleanroom temperature and humidity control panel with room transmitter is listed below.

コア材料	Powder-coated steel control enclosure with FR-4 controller board and polymer room transmitter
パネルの厚さ	160-300 mm enclosure depth
有効幅	400-800 mm panel width
最大長さ	Up to 1200 mm panel height
鋼鉄の厚さを直面する	1.2-1.5 mm powder-coated steel enclosure
コア密度	7800-8050 kg/m³ for steel panel components
熱伝導率	45-60 W/(m·K) for the steel enclosure
表面仕上げ	Fine-textured light-gray powder coat with white room sensor and color HMI
ジョイントタイプ	DIN-rail control panel with removable HVAC output terminals and network connection
カスタマイズ	意図したアプリケーションと動作環境に基づいて利用できます。

利用可能なオプション

Cooling and reheat stagesSteam or ultrasonic humidifier outputDew-point high limitRemote room transmitter

Planning a Temperature and Humidity Control System specification?

寸法、設置条件、性能目標、必要な表面仕上げをお送りください。

チームに相談する