Narrow-spectrum amber cleanroom luminaire illuminated in warm amber

Освещение и электрическое оборудование в чистых помещениях

Амберный свет чистой комнаты

A sealed cleanroom fixture using native amber LEDs to limit short-wavelength exposure in photosensitive process areas.

Native Amber LED Source
Low Blue-Light Output
Sealed Cleanroom Housing
Distinct Yellow Visual Cue

Введение продукции

This luminaire replaces a white phosphor source and colored sleeve with LEDs that emit principally in the amber region. The controlled spectrum is used where photoresists, films or light-sensitive materials must be handled under reduced blue and near-UV energy. The fixture retains the same gasketed white housing and smooth optical face used for general cleanroom lighting, while amber lenses or indicators clearly distinguish the circuit.

Основные характеристики

Native amber emitters avoid relying only on a fading external filter.

The narrow spectrum reduces unwanted short-wavelength energy at the work surface.

A sealed optical chamber protects LEDs and wiring from room cleaning.

Amber identification makes the protected lighting circuit visually obvious.

Dimming allows the illuminance to be matched to the sensitivity of the process.

Обеспокоенность клиентов продуктами

A yellow-looking lamp is not necessarily spectrally suitable; emitted blue energy and filter aging must be considered separately from appearance.

A white LED behind a yellow cover still leaks short-wavelength energy.Native amber emitters minimize blue content at the source.

Colored plastic filters fade after heat and cleaning exposure.The spectral function comes from the LED source rather than only from the cover tint.

Operators accidentally switch on ordinary white lights.Distinct amber fixtures and separately identified controls differentiate the protected circuit.

Excessive intensity can still affect a highly sensitive process.Dimming and layout selection tune illuminance as well as wavelength.

Типичные приложения

Photolithography yellow roomsPhotoresist handlingLight-sensitive film processingPhotosensitive chemical preparation

Технические параметры

Typical configurable construction ranges for a narrow-spectrum amber cleanroom luminaire are listed below.

Основной материал	Powder-coated steel or aluminum housing with native amber LED boards and sealed clear or amber polycarbonate optic
Толщина панели	45-120 mm luminaire body depth
эффективная ширина	100-620 mm exposed fixture width
Максимальная длина	Up to 1500 mm overall luminaire length
Толщина линий стали	0.8-1.2 mm formed steel housing where selected
Плотность ядра	Approximately 1200 kg/m³ for the polycarbonate optical cover
Теплопроводимость	0.20-0.22 W/(m·K) for the polycarbonate optic
Поверхностная отделка	White cleanable exterior with amber-emitting optical face and amber circuit identification
Объединенный тип	Gasketed lens frame with sealed end caps or recessed ceiling flange and protected cable entry
Customization	Доступно в зависимости от предполагаемого применения и операционной среды.

Доступные варианты

Nominal 570 nm or 590 nm sourceRecessed, surface or linear body0-10 V or DALI dimmingAmber-only or amber/white dual circuit

Planning a Amber Cleanroom Light specification?

Отправьте нам ваши габариты, условия монтажа, целевые показатели производительности и требуемую отделку поверхности.

Поговорите с нашей командой