Sistemas de parede e teto para sala limpa

Perfil de cobertura da sala limpa interna

A radiused two-part aluminum cove that replaces a sharp internal junction with a smooth, cleanable transition inside controlled rooms.

Smooth 50 mm internal radius
Two-part clip-on construction
Cleanable powder-coated surface
Suitable for wall, floor and ceiling junctions

Solicite um orçamento. Browse produtos

Introdução do produto

The Internal Cleanroom Coving Profile forms a continuous concave radius where two room surfaces meet. A concealed backing section is fixed first, then the finished cove face clips into position to cover fasteners and bridge the junction. The rounded geometry makes wiping easier than a tight square corner and can remain in place while compatible wall panels are removed from nearby bays.

Características-chave

The concave radius eliminates a difficult-to-reach sharp internal corner.

A separate backing channel keeps primary fixings behind the finished face.

Clip-on assembly creates an even exposed line along long room junctions.

Powder-coated aluminum tolerates routine wipe-down cleaning.

Matching end caps and three-way pieces can finish intersecting cove runs.

Preocupações do produto do cliente

Sharp internal corners are awkward to wipe, visually emphasize sealant irregularities and can collect residue at the meeting point of two surfaces.

Cleaning cloths cannot maintain full contact inside a tight 90-degree recess.A 50 mm concave radius creates a broad, accessible wiping path.

Exposed fixings interrupt the surface at a hygiene-critical junction.The finished cove snaps over its backing channel and conceals the attachment points.

Hand-formed corner sealant often varies in width and appearance.A factory-extruded face establishes a uniform radius along the entire run.

Complex corner intersections require improvised cuts that are hard to seal neatly.Compatible end, internal and three-way accessories provide shaped termination pieces.

Aplicações típicas

Wall-to-ceiling cleanroom junctionsWall-to-wall internal cornersWall-to-floor perimeter transitionsHygienic laboratory interiorsPharmaceutical processing rooms

Parâmetros técnicos

This profile is a finishing component rather than an insulated panel. Its defining dimension is the internal radius and its material properties come from the aluminum extrusion.

Material principal	Two-part 6063 aluminum backing channel and cove face
Painel de espessura	N/A — not applicable to an internal coving profile
Largura efetiva	50 mm standard internal cove radius
Comprimento máximo	3000 mm
Aço enfrentando espessura	N/A — the profile is extruded aluminum
Densidade Core	N/A — no insulated core; aluminum alloy density is approximately 2700 kg/m³
Condutividade térmica	N/A — no insulated core; aluminum alloy is approximately 200 W/(m·K)
Superfície acabado	White polyester powder-coated or clear anodized
Tipo conjunto	Snap-on cove face over a concealed backing channel with sealed edges
Customização	Disponível com base na aplicação pretendida e ambiente operacional

Opções disponíveis

50 mm radius internal coveAlternative 75 mm radiusThree-way internal corner pieceEnd caps and matching sealed transitions

Planning a Internal Cleanroom Coving Profile specification?

Envie-nos as suas dimensões, condições de instalação, metas de desempenho e acabamento de superfície necessário.

Fale com a nossa equipe