클린룸 벽 및 천장 시스템

내부 클린룸 커빙 프로파일

A radiused two-part aluminum cove that replaces a sharp internal junction with a smooth, cleanable transition inside controlled rooms.

Smooth 50 mm internal radius
Two-part clip-on construction
Cleanable powder-coated surface
Suitable for wall, floor and ceiling junctions

견적 요청 제품 찾아보기

상품 소개

The Internal Cleanroom Coving Profile forms a continuous concave radius where two room surfaces meet. A concealed backing section is fixed first, then the finished cove face clips into position to cover fasteners and bridge the junction. The rounded geometry makes wiping easier than a tight square corner and can remain in place while compatible wall panels are removed from nearby bays.

주요 기능

The concave radius eliminates a difficult-to-reach sharp internal corner.

A separate backing channel keeps primary fixings behind the finished face.

Clip-on assembly creates an even exposed line along long room junctions.

Powder-coated aluminum tolerates routine wipe-down cleaning.

Matching end caps and three-way pieces can finish intersecting cove runs.

고객 제품 관심사

Sharp internal corners are awkward to wipe, visually emphasize sealant irregularities and can collect residue at the meeting point of two surfaces.

Cleaning cloths cannot maintain full contact inside a tight 90-degree recess.A 50 mm concave radius creates a broad, accessible wiping path.

Exposed fixings interrupt the surface at a hygiene-critical junction.The finished cove snaps over its backing channel and conceals the attachment points.

Hand-formed corner sealant often varies in width and appearance.A factory-extruded face establishes a uniform radius along the entire run.

Complex corner intersections require improvised cuts that are hard to seal neatly.Compatible end, internal and three-way accessories provide shaped termination pieces.

일반적인 응용 프로그램

Wall-to-ceiling cleanroom junctionsWall-to-wall internal cornersWall-to-floor perimeter transitionsHygienic laboratory interiorsPharmaceutical processing rooms

기술 매개변수

This profile is a finishing component rather than an insulated panel. Its defining dimension is the internal radius and its material properties come from the aluminum extrusion.

핵심 재료	Two-part 6063 aluminum backing channel and cove face
패널 두께	N/A — not applicable to an internal coving profile
유효 폭	50 mm standard internal cove radius
최대 길이	3000 mm
강철 면면 두께	N/A — the profile is extruded aluminum
코어 밀도	N / A - 단열 코어 없음; 알루미늄 합금 밀도는 약 2700 kg / m 3 입니다.
열전도도 (Thermal Conductivity)	N / A - 단열 코어 없음; 알루미늄 합금 약 200 W / (m · K)
표면 마무리	White polyester powder-coated or clear anodized
접합 유형	Snap-on cove face over a concealed backing channel with sealed edges
사용자 정의	사용 대상 어플리케이션 및 운영 환경에 따라 사용 가능

사용 가능한 옵션

50 mm radius internal coveAlternative 75 mm radiusThree-way internal corner pieceEnd caps and matching sealed transitions

Planning a Internal Cleanroom Coving Profile specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.