Inglês
Alemão
Língua árabe
Francês
Língua indonésia
Japonês
Coreano
Língua malaia
Portuguêsatual
Língua russa
Espanhol
Tailandês
Língua turca
Vietnã
Equipamento de manuseio de ar e HVAC para sala limpa
Aquecedor elétrico flangeed duct
A complete flanged duct section containing one six-element electric heater rack, external controls and airflow-related safety devices.
- Single Six-Element Rack
- Flanged Duct Installation
- External Safety Controls
- Withdrawable Heater Assembly
Introdução do produto
The flanged duct heater mounts directly between rectangular duct sections and places six horizontal resistance elements across one airflow opening. Ceramic supports maintain element spacing, while the attached electrical enclosure houses contactors, terminals and high-limit protection. An airflow switch and staged controller prevent full power under inadequate ventilation, and the complete element rack can be withdrawn from the housing for inspection.
Características-chave
Six horizontal elements form one uniform bank rather than separate obstructive columns.
The external control enclosure keeps contactors and wiring out of the heated airflow.
A manual-reset high limit and airflow interlock interrupt heating before unsafe temperature rise.
Preocupações do produto do cliente
A duct heater must match airflow, electrical load and safety control without creating a high-pressure obstruction.
Low airflow can overheat the elements and adjacent duct insulation.Airflow proving and independent high-limit cutouts interrupt the contactor circuit.
Multiple narrow element columns cause uneven leaving-air temperature.One six-element rack spans the active width with consistent horizontal spacing.
Service access requires dismantling long duct runs.The heater rack withdraws laterally while the flanged outer housing remains installed.
Power switching generates heat and dust inside the airstream.Contactors, fuses and terminals are enclosed in the external side control cabinet.
Aplicações típicas
Cleanroom supply-duct trim heatingOutdoor-air temperingTerminal reheat branchesLaboratory exhaust replacement airProcess-air temperature maintenance
Parâmetros técnicos
Representative dimensions and materials for a single-bank flanged duct heater are listed below.
| Material principal | Nickel-chromium resistance elements on ceramic supports inside galvanized duct housing |
|---|---|
| Painel de espessura | 1.0-1.5 mm galvanized duct casing thickness |
| Largura efetiva | 300-1800 mm active duct opening width |
| Comprimento máximo | Up to 900 mm overall casing depth in the airflow direction |
| Aço enfrentando espessura | 1.0-1.5 mm galvanized casing and control-box sheet |
| Densidade Core | Approximately 8300 kg/m³ for the nickel-chromium resistance elements |
| Condutividade térmica | Approximately 15 W/(m·K) for nickel-chromium resistance wire at room temperature |
| Superfície acabado | Bright galvanized steel housing with exposed nickel-chromium elements and glazed ceramic supports |
| Tipo conjunto | Bolted duct flanges with slide-out six-element rack and gasketed control enclosure |
| Customização | Disponível com base na aplicação pretendida e no ambiente operacional. |
Opções disponíveis
Staged contactor, SCR or thyristor controlAirflow switch and differential-pressure provingAutomatic and manual-reset high limitsCustom flange size, voltage and control-box side
Planning a Flanged Duct Electric Heater specification?
Envie-nos as suas dimensões, condições de instalação, metas de desempenho e acabamento de superfície necessário.
