Flanged duct electric heater with six horizontal elements

클린룸 HVAC 및 공기 처리 장비

플랜지 덕트 전기 히터

A complete flanged duct section containing one six-element electric heater rack, external controls and airflow-related safety devices.

Single Six-Element Rack
Flanged Duct Installation
External Safety Controls
Withdrawable Heater Assembly

견적 요청 제품 찾아보기

상품 소개

The flanged duct heater mounts directly between rectangular duct sections and places six horizontal resistance elements across one airflow opening. Ceramic supports maintain element spacing, while the attached electrical enclosure houses contactors, terminals and high-limit protection. An airflow switch and staged controller prevent full power under inadequate ventilation, and the complete element rack can be withdrawn from the housing for inspection.

주요 기능

Matching inlet and outlet flanges make the heater a self-contained rectangular duct module.

Six horizontal elements form one uniform bank rather than separate obstructive columns.

The external control enclosure keeps contactors and wiring out of the heated airflow.

A manual-reset high limit and airflow interlock interrupt heating before unsafe temperature rise.

고객 제품 관심사

A duct heater must match airflow, electrical load and safety control without creating a high-pressure obstruction.

Low airflow can overheat the elements and adjacent duct insulation.Airflow proving and independent high-limit cutouts interrupt the contactor circuit.

Multiple narrow element columns cause uneven leaving-air temperature.One six-element rack spans the active width with consistent horizontal spacing.

Service access requires dismantling long duct runs.The heater rack withdraws laterally while the flanged outer housing remains installed.

Power switching generates heat and dust inside the airstream.Contactors, fuses and terminals are enclosed in the external side control cabinet.

일반적인 응용 프로그램

Cleanroom supply-duct trim heatingOutdoor-air temperingTerminal reheat branchesLaboratory exhaust replacement airProcess-air temperature maintenance

기술 매개변수

Representative dimensions and materials for a single-bank flanged duct heater are listed below.

핵심 재료	Nickel-chromium resistance elements on ceramic supports inside galvanized duct housing
패널 두께	1.0-1.5 mm galvanized duct casing thickness
유효 폭	300-1800 mm active duct opening width
최대 길이	Up to 900 mm overall casing depth in the airflow direction
강철 면면 두께	1.0-1.5 mm galvanized casing and control-box sheet
코어 밀도	Approximately 8300 kg/m³ for the nickel-chromium resistance elements
열전도도 (Thermal Conductivity)	Approximately 15 W/(m·K) for nickel-chromium resistance wire at room temperature
표면 마무리	Bright galvanized steel housing with exposed nickel-chromium elements and glazed ceramic supports
접합 유형	Bolted duct flanges with slide-out six-element rack and gasketed control enclosure
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

사용 가능한 옵션

Staged contactor, SCR or thyristor controlAirflow switch and differential-pressure provingAutomatic and manual-reset high limitsCustom flange size, voltage and control-box side

Planning a Flanged Duct Electric Heater specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.