Anglais
Allemand
Arabe
FrançaisCurrent
Indonésien
Japonais
Coréen
Le malais
Le portugais
russe
espagnol
Thaïlandais
Le turc
Le vietnamien
Salle blanche HVAC et équipement de manutention de l'air
Chauffage électrique à conduit à brides
A complete flanged duct section containing one six-element electric heater rack, external controls and airflow-related safety devices.
- Single Six-Element Rack
- Flanged Duct Installation
- External Safety Controls
- Withdrawable Heater Assembly
Introduction de produit
The flanged duct heater mounts directly between rectangular duct sections and places six horizontal resistance elements across one airflow opening. Ceramic supports maintain element spacing, while the attached electrical enclosure houses contactors, terminals and high-limit protection. An airflow switch and staged controller prevent full power under inadequate ventilation, and the complete element rack can be withdrawn from the housing for inspection.
Key Features
Six horizontal elements form one uniform bank rather than separate obstructive columns.
The external control enclosure keeps contactors and wiring out of the heated airflow.
A manual-reset high limit and airflow interlock interrupt heating before unsafe temperature rise.
Préoccupations du client produit
A duct heater must match airflow, electrical load and safety control without creating a high-pressure obstruction.
Low airflow can overheat the elements and adjacent duct insulation.Airflow proving and independent high-limit cutouts interrupt the contactor circuit.
Multiple narrow element columns cause uneven leaving-air temperature.One six-element rack spans the active width with consistent horizontal spacing.
Service access requires dismantling long duct runs.The heater rack withdraws laterally while the flanged outer housing remains installed.
Power switching generates heat and dust inside the airstream.Contactors, fuses and terminals are enclosed in the external side control cabinet.
Les applications typiques
Cleanroom supply-duct trim heatingOutdoor-air temperingTerminal reheat branchesLaboratory exhaust replacement airProcess-air temperature maintenance
Paramètres techniques
Representative dimensions and materials for a single-bank flanged duct heater are listed below.
| Matériaux de base | Nickel-chromium resistance elements on ceramic supports inside galvanized duct housing |
|---|---|
| Panneau épaisseur | 1.0-1.5 mm galvanized duct casing thickness |
| Largeur effective | 300-1800 mm active duct opening width |
| Longueur maximale | Up to 900 mm overall casing depth in the airflow direction |
| Acier face épaisseur | 1.0-1.5 mm galvanized casing and control-box sheet |
| Densité Core | Approximately 8300 kg/m³ for the nickel-chromium resistance elements |
| Conductivité thermique | Approximately 15 W/(m·K) for nickel-chromium resistance wire at room temperature |
| surface finie | Bright galvanized steel housing with exposed nickel-chromium elements and glazed ceramic supports |
| Type joint | Bolted duct flanges with slide-out six-element rack and gasketed control enclosure |
| Customisation | Disponible en fonction de l'application prévue et de l'environnement d'exploitation. |
Options disponibles
Staged contactor, SCR or thyristor controlAirflow switch and differential-pressure provingAutomatic and manual-reset high limitsCustom flange size, voltage and control-box side
Planning a Flanged Duct Electric Heater specification?
Envoyez-nous vos dimensions, conditions d'installation, objectifs de performance et finition de surface requise.
