PIR pre-insulated air duct with aluminum foil facings and rigid foam core

Temiz Oda Hava Dağıtım Sistemleri

PIR Ön yalıtımlı hava borusu

A lightweight rigid duct fabricated from closed-cell PIR panels with aluminum foil facings that combine the air barrier and thermal insulation in one assembly.

Closed-Cell PIR Core
Integrated Thermal Insulation
Aluminum Foil Facings
Lightweight Panel Assembly

Alıntı isteği Browse ürünleri

Ürün tanıtımı

PIR pre-insulated ductwork is cut and folded from rigid closed-cell panels faced on both sides with aluminum foil. The finished duct eliminates the separate sheet-metal shell and external insulation layer used in conventional systems, reducing installed weight and limiting thermal bridges. Male-female panel edges, aluminum profiles, vapor-tight foil tape and compatible sealant form the longitudinal and transverse joints. The smooth foil interior suits dry conditioned supply and return air where the panel is protected from impact and the selected facing is compatible with cleaning practices.

Ana Özellikler

Low-conductivity PIR foam provides useful thermal resistance with a compact 20–30 mm wall.

Continuous foil facings create clean internal and external surfaces and support vapor control.

The combined duct-and-insulation panel reduces suspended load and installation operations.

Factory-routed grooves and aluminum closure profiles produce accurate corners and branch fittings.

Müşteri Ürün Sorunları

A pre-insulated duct must preserve an uninterrupted vapor barrier and protect its foam edges from air leakage, moisture and jobsite damage.

Separate metal duct and insulation increase ceiling load and labor.One rigid PIR panel performs as the duct wall and thermal insulation layer.

Foil cuts at corners become paths for condensation moisture.Continuous foil tape, formed corner profiles and compatible sealant close every exposed edge.

Foam panels are damaged around hangers and service openings.Load-spreading support saddles and reinforced penetrations protect the low-density core.

Field-made joints vary in alignment and air tightness.Matched edge profiles and controlled cutting templates produce repeatable section geometry.

Tipik uygulamalar

Indoor cleanroom supply ductsReturn-air distributionLow-load suspended ceiling routesHumidity-controlled HVAC branchesPrefabricated mechanical modules

Teknik parametreler

Typical material data for aluminum-faced PIR pre-insulated duct panels are listed below.

Temel malzemeler	Closed-cell polyisocyanurate (PIR) rigid foam
Panel kalınlığı	20–30 mm
Effective Width (Etkili Genişlik)	1200 mm standard panel width
Maksimum uzunluk	4000 mm standard panel length
Çelik yüz yüze kalınlığı	0.06–0.20 mm embossed aluminum foil facing on each side
Core Density (Çekirdek Yoğunluğu)	45–55 kg/m³
Termal İletkenlik	0.020–0.023 W/(m·K) at approximately 10–25°C mean temperature
Yüzey bitirme	Embossed or smooth aluminum foil laminate on internal and external faces
Ortak tip	Male-female panel joint with aluminum profile, foil tape and vapor-tight sealant
Customization (Özelleşme)	Kullanılan uygulama ve çalışma ortamına göre kullanılabilir.

Mevcut Seçenekler

Antimicrobial coated interior foilReinforced external aluminum facingFlanged equipment connection profilesRectangular fittings and branch modules

Planning a PIR Pre-Insulated Air Duct specification?

Bize boyutlarınızı, montaj koşullarınızı, performans hedeflerinizi ve gerekli yüzey kaplamalarınızı gönderin.

Ekibimizle konuşun