PIR pre-insulated air duct with aluminum foil facings and rigid foam core

Sistem Pengedaran Udara Bilik Bersih

Saluran udara pra-tebat PIR

A lightweight rigid duct fabricated from closed-cell PIR panels with aluminum foil facings that combine the air barrier and thermal insulation in one assembly.

Closed-Cell PIR Core
Integrated Thermal Insulation
Aluminum Foil Facings
Lightweight Panel Assembly

Permintaan sebut harga Semak imbas produk

Pengenalan Produk

PIR pre-insulated ductwork is cut and folded from rigid closed-cell panels faced on both sides with aluminum foil. The finished duct eliminates the separate sheet-metal shell and external insulation layer used in conventional systems, reducing installed weight and limiting thermal bridges. Male-female panel edges, aluminum profiles, vapor-tight foil tape and compatible sealant form the longitudinal and transverse joints. The smooth foil interior suits dry conditioned supply and return air where the panel is protected from impact and the selected facing is compatible with cleaning practices.

Ciri-ciri Utama

Low-conductivity PIR foam provides useful thermal resistance with a compact 20–30 mm wall.

Continuous foil facings create clean internal and external surfaces and support vapor control.

The combined duct-and-insulation panel reduces suspended load and installation operations.

Factory-routed grooves and aluminum closure profiles produce accurate corners and branch fittings.

Kebimbangan Produk Pelanggan

A pre-insulated duct must preserve an uninterrupted vapor barrier and protect its foam edges from air leakage, moisture and jobsite damage.

Separate metal duct and insulation increase ceiling load and labor.One rigid PIR panel performs as the duct wall and thermal insulation layer.

Foil cuts at corners become paths for condensation moisture.Continuous foil tape, formed corner profiles and compatible sealant close every exposed edge.

Foam panels are damaged around hangers and service openings.Load-spreading support saddles and reinforced penetrations protect the low-density core.

Field-made joints vary in alignment and air tightness.Matched edge profiles and controlled cutting templates produce repeatable section geometry.

Permohonan yang biasa

Indoor cleanroom supply ductsReturn-air distributionLow-load suspended ceiling routesHumidity-controlled HVAC branchesPrefabricated mechanical modules

Parameter teknikal

Typical material data for aluminum-faced PIR pre-insulated duct panels are listed below.

Bahan Teras	Closed-cell polyisocyanurate (PIR) rigid foam
Ketebalan Panel	20–30 mm
Lebar berkesan	1200 mm standard panel width
Panjang maksimum	4000 mm standard panel length
Keluli Menghadapi Ketebalan	0.06–0.20 mm embossed aluminum foil facing on each side
Ketumpatan teras	45–55 kg/m³
Kekonduksian Terma	0.020–0.023 W/(m·K) at approximately 10–25°C mean temperature
Kemasan permukaan	Embossed or smooth aluminum foil laminate on internal and external faces
Jenis Bersatu	Male-female panel joint with aluminum profile, foil tape and vapor-tight sealant
Penyesuaian	Boleh didapati berdasarkan aplikasi yang dimaksudkan dan persekitaran operasi.

Pilihan yang boleh didapati

Antimicrobial coated interior foilReinforced external aluminum facingFlanged equipment connection profilesRectangular fittings and branch modules

Planning a PIR Pre-Insulated Air Duct specification?

Hantarkan kepada kami dimensi anda, syarat pemasangan, sasaran prestasi dan kemasan permukaan yang diperlukan.

Berbincang dengan pasukan kami