PIR pre-insulated air duct with aluminum foil facings and rigid foam core

Системы распределения воздуха в чистых помещениях

PIR предварительно изоляция воздуховода

A lightweight rigid duct fabricated from closed-cell PIR panels with aluminum foil facings that combine the air barrier and thermal insulation in one assembly.

Closed-Cell PIR Core
Integrated Thermal Insulation
Aluminum Foil Facings
Lightweight Panel Assembly

Запрос котировки Просмотреть продукты

Введение продукции

PIR pre-insulated ductwork is cut and folded from rigid closed-cell panels faced on both sides with aluminum foil. The finished duct eliminates the separate sheet-metal shell and external insulation layer used in conventional systems, reducing installed weight and limiting thermal bridges. Male-female panel edges, aluminum profiles, vapor-tight foil tape and compatible sealant form the longitudinal and transverse joints. The smooth foil interior suits dry conditioned supply and return air where the panel is protected from impact and the selected facing is compatible with cleaning practices.

Основные характеристики

Low-conductivity PIR foam provides useful thermal resistance with a compact 20–30 mm wall.

Continuous foil facings create clean internal and external surfaces and support vapor control.

The combined duct-and-insulation panel reduces suspended load and installation operations.

Factory-routed grooves and aluminum closure profiles produce accurate corners and branch fittings.

Обеспокоенность клиентов продуктами

A pre-insulated duct must preserve an uninterrupted vapor barrier and protect its foam edges from air leakage, moisture and jobsite damage.

Separate metal duct and insulation increase ceiling load and labor.One rigid PIR panel performs as the duct wall and thermal insulation layer.

Foil cuts at corners become paths for condensation moisture.Continuous foil tape, formed corner profiles and compatible sealant close every exposed edge.

Foam panels are damaged around hangers and service openings.Load-spreading support saddles and reinforced penetrations protect the low-density core.

Field-made joints vary in alignment and air tightness.Matched edge profiles and controlled cutting templates produce repeatable section geometry.

Типичные приложения

Indoor cleanroom supply ductsReturn-air distributionLow-load suspended ceiling routesHumidity-controlled HVAC branchesPrefabricated mechanical modules

Технические параметры

Typical material data for aluminum-faced PIR pre-insulated duct panels are listed below.

Основной материал	Closed-cell polyisocyanurate (PIR) rigid foam
Толщина панели	20–30 mm
эффективная ширина	1200 mm standard panel width
Максимальная длина	4000 mm standard panel length
Толщина линий стали	0.06–0.20 mm embossed aluminum foil facing on each side
Плотность ядра	45–55 kg/m³
Теплопроводимость	0.020–0.023 W/(m·K) at approximately 10–25°C mean temperature
Поверхностная отделка	Embossed or smooth aluminum foil laminate on internal and external faces
Объединенный тип	Male-female panel joint with aluminum profile, foil tape and vapor-tight sealant
Customization	Доступно в зависимости от предполагаемого применения и операционной среды.

Доступные варианты

Antimicrobial coated interior foilReinforced external aluminum facingFlanged equipment connection profilesRectangular fittings and branch modules

Planning a PIR Pre-Insulated Air Duct specification?

Отправьте нам ваши габариты, условия монтажа, целевые показатели производительности и требуемую отделку поверхности.

Поговорите с нашей командой