Стенные и потолочные системы для чистых комнат

HPL Cleanroom Wall Liner Panel

A compact high-pressure laminate lining system fixed over an existing wall, creating a hard, moisture-tolerant and easy-to-wipe cleanroom surface without building a second insulated partition.

12 mm Compact HPL Face
Concealed Mechanical Supports
Impact-Resistant Wall Upgrade
Sealed Vertical Connections

Запрос котировки Просмотреть продукты

Введение продукции

HPL Cleanroom Wall Liner Panels use a homogeneous compact laminate sheet carried on concealed aluminum support profiles. The liner sits in front of masonry, concrete or framed construction and converts the substrate into a smooth controlled-environment finish. Interlocking vertical profiles hold each sheet without exposed front fasteners, while the recessed base detail can meet a sheet-vinyl or resin floor with minimal ledges. Because the sheet itself is dense and self-supporting, the system does not depend on a foam or mineral insulation core.

Основные характеристики

Dense thermoset laminate resists everyday impact and abrasion in busy internal areas.

Mechanical attachment avoids wet bonding over the entire existing wall surface.

Concealed vertical profiles keep screws and clips away from the cleanable face.

Compact HPL can be machined for sockets, controls and service penetrations before fitting.

Individual sheets remain accessible for localized replacement after surface damage.

Обеспокоенность клиентов продуктами

Wall-lining buyers focus on substrate irregularity, edge moisture, visible fasteners and repair access in occupied facilities.

Uneven masonry produces visible waves when thin decorative sheets are bonded directly to it.Adjustable vertical supports establish a straight plane before the compact laminate is attached.

Open HPL edges can absorb moisture or collect residue near floors and service holes.Recessed base profiles, closed cut-out trims and continuous joint sealant protect exposed edges.

Surface screws create cleaning obstructions across a newly lined wall.Interlocking rear profiles retain the sheets while leaving the room face free of visible mechanical fixings.

A damaged section of permanently bonded cladding is difficult to remove neatly.Modular support profiles allow one liner sheet to be released without stripping the complete elevation.

Типичные приложения

HPL laboratory lining upgradesPharmaceutical support roomsHospital clean corridorsMedical-device assembly areasGowning and personnel-change rooms

Технические параметры

Common production dimensions for compact HPL cleanroom liner systems are listed below.

Основной материал	N/A — homogeneous compact high-pressure laminate has no separate core
Толщина панели	12 mm
эффективная ширина	1286 mm
Максимальная длина	3000 mm
Толщина линий стали	N/A — compact HPL liner has no steel facing
Плотность ядра	N/A — the liner is a solid laminate sheet rather than a low-density core panel
Теплопроводимость	N/A — wall liner is not used as a thermal-insulation component
Поверхностная отделка	Smooth low-texture compact HPL in cleanroom white or selected solid colour
Объединенный тип	Concealed interlocking vertical supports with 20 × 30 mm joint tube and sealed face joint
Customization	Доступно в зависимости от предполагаемого приложения и операционной среды

Доступные варианты

Recessed or floor-reaching base detailAlternative solid HPL coloursPre-machined utility openingsInternal corner and end-closure profiles

Planning a HPL Cleanroom Wall Liner Panel specification?

Отправьте нам ваши габариты, условия монтажа, целевые показатели производительности и требуемую отделку поверхности.

Поговорите с нашей командой