Cleanroom mur et systèmes de plafond

HPL Cleanroom Wall Liner Panel

A compact high-pressure laminate lining system fixed over an existing wall, creating a hard, moisture-tolerant and easy-to-wipe cleanroom surface without building a second insulated partition.

12 mm Compact HPL Face
Concealed Mechanical Supports
Impact-Resistant Wall Upgrade
Sealed Vertical Connections

Demander un devis. Browse les produits

Introduction de produit

HPL Cleanroom Wall Liner Panels use a homogeneous compact laminate sheet carried on concealed aluminum support profiles. The liner sits in front of masonry, concrete or framed construction and converts the substrate into a smooth controlled-environment finish. Interlocking vertical profiles hold each sheet without exposed front fasteners, while the recessed base detail can meet a sheet-vinyl or resin floor with minimal ledges. Because the sheet itself is dense and self-supporting, the system does not depend on a foam or mineral insulation core.

Key Features

Dense thermoset laminate resists everyday impact and abrasion in busy internal areas.

Mechanical attachment avoids wet bonding over the entire existing wall surface.

Concealed vertical profiles keep screws and clips away from the cleanable face.

Compact HPL can be machined for sockets, controls and service penetrations before fitting.

Individual sheets remain accessible for localized replacement after surface damage.

Préoccupations du client produit

Wall-lining buyers focus on substrate irregularity, edge moisture, visible fasteners and repair access in occupied facilities.

Uneven masonry produces visible waves when thin decorative sheets are bonded directly to it.Adjustable vertical supports establish a straight plane before the compact laminate is attached.

Open HPL edges can absorb moisture or collect residue near floors and service holes.Recessed base profiles, closed cut-out trims and continuous joint sealant protect exposed edges.

Surface screws create cleaning obstructions across a newly lined wall.Interlocking rear profiles retain the sheets while leaving the room face free of visible mechanical fixings.

A damaged section of permanently bonded cladding is difficult to remove neatly.Modular support profiles allow one liner sheet to be released without stripping the complete elevation.

Les applications typiques

HPL laboratory lining upgradesPharmaceutical support roomsHospital clean corridorsMedical-device assembly areasGowning and personnel-change rooms

Paramètres techniques

Common production dimensions for compact HPL cleanroom liner systems are listed below.

Matériaux de base	N/A — homogeneous compact high-pressure laminate has no separate core
Panneau épaisseur	12 mm
Largeur effective	1286 mm
Longueur maximale	3000 mm
Acier face épaisseur	N/A — compact HPL liner has no steel facing
Densité Core	N/A — the liner is a solid laminate sheet rather than a low-density core panel
Conductivité thermique	N/A — wall liner is not used as a thermal-insulation component
surface finie	Smooth low-texture compact HPL in cleanroom white or selected solid colour
Type joint	Concealed interlocking vertical supports with 20 × 30 mm joint tube and sealed face joint
Customisation	Disponible en fonction de l'application prévue et de l'environnement d'exploitation

Options disponibles

Recessed or floor-reaching base detailAlternative solid HPL coloursPre-machined utility openingsInternal corner and end-closure profiles

Planning a HPL Cleanroom Wall Liner Panel specification?

Envoyez-nous vos dimensions, conditions d'installation, objectifs de performance et finition de surface requise.

Parlez à notre équipe