Complete HPL cleanroom wall liner panel with concealed support profiles

클린룸 벽 및 천장 시스템

HPL 클린룸 벽면 패널

A compact high-pressure laminate lining system fixed over an existing wall, creating a hard, moisture-tolerant and easy-to-wipe cleanroom surface without building a second insulated partition.

12 mm Compact HPL Face
Concealed Mechanical Supports
Impact-Resistant Wall Upgrade
Sealed Vertical Connections

견적 요청 제품 찾아보기

상품 소개

HPL Cleanroom Wall Liner Panels use a homogeneous compact laminate sheet carried on concealed aluminum support profiles. The liner sits in front of masonry, concrete or framed construction and converts the substrate into a smooth controlled-environment finish. Interlocking vertical profiles hold each sheet without exposed front fasteners, while the recessed base detail can meet a sheet-vinyl or resin floor with minimal ledges. Because the sheet itself is dense and self-supporting, the system does not depend on a foam or mineral insulation core.

주요 기능

Dense thermoset laminate resists everyday impact and abrasion in busy internal areas.

Mechanical attachment avoids wet bonding over the entire existing wall surface.

Concealed vertical profiles keep screws and clips away from the cleanable face.

Compact HPL can be machined for sockets, controls and service penetrations before fitting.

Individual sheets remain accessible for localized replacement after surface damage.

고객 제품 관심사

Wall-lining buyers focus on substrate irregularity, edge moisture, visible fasteners and repair access in occupied facilities.

Uneven masonry produces visible waves when thin decorative sheets are bonded directly to it.Adjustable vertical supports establish a straight plane before the compact laminate is attached.

Open HPL edges can absorb moisture or collect residue near floors and service holes.Recessed base profiles, closed cut-out trims and continuous joint sealant protect exposed edges.

Surface screws create cleaning obstructions across a newly lined wall.Interlocking rear profiles retain the sheets while leaving the room face free of visible mechanical fixings.

A damaged section of permanently bonded cladding is difficult to remove neatly.Modular support profiles allow one liner sheet to be released without stripping the complete elevation.

일반적인 응용 프로그램

HPL laboratory lining upgradesPharmaceutical support roomsHospital clean corridorsMedical-device assembly areasGowning and personnel-change rooms

기술 매개변수

Common production dimensions for compact HPL cleanroom liner systems are listed below.

핵심 재료	N/A — homogeneous compact high-pressure laminate has no separate core
패널 두께	12 mm
유효 폭	1286 mm
최대 길이	3000 mm
강철 면면 두께	N/A — compact HPL liner has no steel facing
코어 밀도	N/A — the liner is a solid laminate sheet rather than a low-density core panel
열전도도 (Thermal Conductivity)	N/A — wall liner is not used as a thermal-insulation component
표면 마무리	Smooth low-texture compact HPL in cleanroom white or selected solid colour
접합 유형	Concealed interlocking vertical supports with 20 × 30 mm joint tube and sealed face joint
사용자 정의	사용 대상 어플리케이션 및 운영 환경에 따라 사용 가능

사용 가능한 옵션

Recessed or floor-reaching base detailAlternative solid HPL coloursPre-machined utility openingsInternal corner and end-closure profiles

Planning a HPL Cleanroom Wall Liner Panel specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.