English
Немецкий
Арабский язык
Французский
Индонезийский
Японский язык
Корейский
Японский
Португальский
Русский языкТекущий
Испанский язык
Тайский
Турецкий
Вьетнамский язык
Запчасти для оборудования для чистых помещений
FFU гель уплотнение
A refillable fluid-gel trough that forms a conformable low-bypass seal around an FFU HEPA filter knife-edge interface.
- Continuous Fluid-Gel Barrier
- Knife-Edge Interface
- Refillable Aluminum Trough
- Conformable Low-Bypass Seal
Введение продукции
The FFU gel seal uses a continuous channel of stable silicone gel to receive the projecting knife edge of a mating HEPA filter or housing. As the knife edge enters the gel, the fluid conforms around minor dimensional variation without the compression load required by a foam gasket. An aluminum trough retains the gel around the full perimeter, with sealed corners and an optional fill port for controlled service. Trough dimensions, gel depth, viscosity and knife-edge immersion must match the installed filter system.
Основные характеристики
A rigid aluminum trough controls gel depth and prevents migration from the sealing path.
Mitered or welded corner construction maintains channel continuity at perimeter turns.
A capped fill port supports controlled topping-up or replacement of compatible gel.
Обеспокоенность клиентов продуктами
A fluid seal only performs reliably when the trough remains continuous and the mating knife edge reaches the correct gel depth.
Insufficient gel depth leaves sections of the knife edge unsealed.Trough volume and fill level are matched to the knife-edge height and intended immersion.
Corner discontinuities become bypass paths around an otherwise sealed perimeter.Sealed corner joints maintain one uninterrupted gel channel around the frame.
Incompatible gel hardens, flows or contaminates the mating surface.Gel chemistry and consistency are selected for the operating temperature and filter interface materials.
Overfilling causes gel displacement during filter installation.A defined trough profile and controlled refill quantity keep the gel below its retention lips.
Типичные приложения
Gel-seal FFU HEPA interfacesCleanroom terminal filter housingsPharmaceutical ceiling filter modulesLow-bypass filter replacement systems
Технические параметры
Typical construction ranges for FFU fluid-gel seal troughs are shown below.
| Основной материал | Non-curing silicone sealing gel retained in an aluminum perimeter trough |
|---|---|
| Толщина панели | 15-40 mm nominal trough depth |
| эффективная ширина | 300-610 mm nominal frame width |
| Максимальная длина | Up to 1220 mm nominal frame length |
| Толщина линий стали | 0.8-1.5 mm optional stainless-steel cover or retaining component |
| Плотность ядра | Approximately 950-1050 kg/m³ for the silicone gel |
| Теплопроводимость | Approximately 0.15-0.25 W/(m·K) for silicone sealing gel |
| Поверхностная отделка | Natural silver aluminum trough with translucent blue or clear silicone gel |
| Объединенный тип | Continuous U-channel trough with sealed mitered corners and optional capped fill port |
| Customization | Доступно в зависимости от предполагаемого применения и операционной среды. |
Доступные варианты
Blue or clear compatible gelCustom trough dimensionsCapped fill and drain portsMatched knife-edge immersion depth
Planning a FFU Gel Seal specification?
Отправьте нам ваши габариты, условия монтажа, целевые показатели производительности и требуемую отделку поверхности.
