Three-quarter view of an FFU gel-seal trough with continuous blue silicone gel

クリーンルーム機器のスペアパーツ

FFU ゲルシール

A refillable fluid-gel trough that forms a conformable low-bypass seal around an FFU HEPA filter knife-edge interface.

Continuous Fluid-Gel Barrier
Knife-Edge Interface
Refillable Aluminum Trough
Conformable Low-Bypass Seal

商品紹介

The FFU gel seal uses a continuous channel of stable silicone gel to receive the projecting knife edge of a mating HEPA filter or housing. As the knife edge enters the gel, the fluid conforms around minor dimensional variation without the compression load required by a foam gasket. An aluminum trough retains the gel around the full perimeter, with sealed corners and an optional fill port for controlled service. Trough dimensions, gel depth, viscosity and knife-edge immersion must match the installed filter system.

主要な特徴

Continuous fluid gel conforms around the mating knife edge along all four sides.

A rigid aluminum trough controls gel depth and prevents migration from the sealing path.

Mitered or welded corner construction maintains channel continuity at perimeter turns.

A capped fill port supports controlled topping-up or replacement of compatible gel.

お客様の製品に関する懸念事項

A fluid seal only performs reliably when the trough remains continuous and the mating knife edge reaches the correct gel depth.

Insufficient gel depth leaves sections of the knife edge unsealed.Trough volume and fill level are matched to the knife-edge height and intended immersion.

Corner discontinuities become bypass paths around an otherwise sealed perimeter.Sealed corner joints maintain one uninterrupted gel channel around the frame.

Incompatible gel hardens, flows or contaminates the mating surface.Gel chemistry and consistency are selected for the operating temperature and filter interface materials.

Overfilling causes gel displacement during filter installation.A defined trough profile and controlled refill quantity keep the gel below its retention lips.

典型的な用途

Gel-seal FFU HEPA interfacesCleanroom terminal filter housingsPharmaceutical ceiling filter modulesLow-bypass filter replacement systems

技術的なパラメータ

Typical construction ranges for FFU fluid-gel seal troughs are shown below.

コア材料	Non-curing silicone sealing gel retained in an aluminum perimeter trough
パネルの厚さ	15-40 mm nominal trough depth
有効幅	300-610 mm nominal frame width
最大長さ	Up to 1220 mm nominal frame length
鋼鉄の厚さを直面する	0.8-1.5 mm optional stainless-steel cover or retaining component
コア密度	Approximately 950-1050 kg/m³ for the silicone gel
熱伝導率	Approximately 0.15-0.25 W/(m·K) for silicone sealing gel
表面仕上げ	Natural silver aluminum trough with translucent blue or clear silicone gel
ジョイントタイプ	Continuous U-channel trough with sealed mitered corners and optional capped fill port
カスタマイズ	意図したアプリケーションと動作環境に基づいて利用できます。

利用可能なオプション

Blue or clear compatible gelCustom trough dimensionsCapped fill and drain portsMatched knife-edge immersion depth

Planning a FFU Gel Seal specification?

寸法、設置条件、性能目標、必要な表面仕上げをお送りください。

チームに相談する