Bahasa Inggris
Bahasa Jerman
Bahasa Arab
Bahasa Perancis: Bahasa Perancis
Bahasa IndonesiaSaat ini
Bahasa Jepang
Bahasa Korea
Bahasa Melayu
Bahasa Portugis
Bahasa Rusia
Bahasa Spanyol
Bahasa Thailand
Bahasa Turki
Bahasa Vietnam
Cleanroom Equipment Spare Parts
FFU Gel Seal
A refillable fluid-gel trough that forms a conformable low-bypass seal around an FFU HEPA filter knife-edge interface.
- Continuous Fluid-Gel Barrier
- Knife-Edge Interface
- Refillable Aluminum Trough
- Conformable Low-Bypass Seal
Perkenalan produk
The FFU gel seal uses a continuous channel of stable silicone gel to receive the projecting knife edge of a mating HEPA filter or housing. As the knife edge enters the gel, the fluid conforms around minor dimensional variation without the compression load required by a foam gasket. An aluminum trough retains the gel around the full perimeter, with sealed corners and an optional fill port for controlled service. Trough dimensions, gel depth, viscosity and knife-edge immersion must match the installed filter system.
Fitur utama:
A rigid aluminum trough controls gel depth and prevents migration from the sealing path.
Mitered or welded corner construction maintains channel continuity at perimeter turns.
A capped fill port supports controlled topping-up or replacement of compatible gel.
Kekhawatiran produk pelanggan
A fluid seal only performs reliably when the trough remains continuous and the mating knife edge reaches the correct gel depth.
Insufficient gel depth leaves sections of the knife edge unsealed.Trough volume and fill level are matched to the knife-edge height and intended immersion.
Corner discontinuities become bypass paths around an otherwise sealed perimeter.Sealed corner joints maintain one uninterrupted gel channel around the frame.
Incompatible gel hardens, flows or contaminates the mating surface.Gel chemistry and consistency are selected for the operating temperature and filter interface materials.
Overfilling causes gel displacement during filter installation.A defined trough profile and controlled refill quantity keep the gel below its retention lips.
Aplikasi yang Tipis
Gel-seal FFU HEPA interfacesCleanroom terminal filter housingsPharmaceutical ceiling filter modulesLow-bypass filter replacement systems
Parameter teknis
Typical construction ranges for FFU fluid-gel seal troughs are shown below.
| Bahan inti | Non-curing silicone sealing gel retained in an aluminum perimeter trough |
|---|---|
| Ketebalan Panel (Panel Thickness) | 15-40 mm nominal trough depth |
| Efektif lebar | 300-610 mm nominal frame width |
| Panjang maksimum | Up to 1220 mm nominal frame length |
| Baja menghadap ketebalan | 0.8-1.5 mm optional stainless-steel cover or retaining component |
| Kepadatan inti (core density) | Approximately 950-1050 kg/m³ for the silicone gel |
| Konduktivitas Termal (Thermal Conductivity) | Approximately 0.15-0.25 W/(m·K) for silicone sealing gel |
| Permukaan selesai | Natural silver aluminum trough with translucent blue or clear silicone gel |
| Jenis Bersama | Continuous U-channel trough with sealed mitered corners and optional capped fill port |
| Customization (Kustomisasi) | Tersedia berdasarkan aplikasi yang dimaksudkan dan lingkungan operasi. |
Pilihan yang tersedia
Blue or clear compatible gelCustom trough dimensionsCapped fill and drain portsMatched knife-edge immersion depth
Planning a FFU Gel Seal specification?
Kirimkan kami dimensi Anda, kondisi instalasi, target kinerja dan permukaan akhir yang diperlukan.
