Englisch
DeutschCurrent
Arabisch
Französisch
indonesisch
Japanisch
Koreanisch
Malaiisch
Portugiesisch
Russisch
Spanisch
Thailändisch
Türkischer Sprache
Vietnamesisch
Cleanroom Equipment Ersatzteile
FFU Gel Siegel
A refillable fluid-gel trough that forms a conformable low-bypass seal around an FFU HEPA filter knife-edge interface.
- Continuous Fluid-Gel Barrier
- Knife-Edge - Schnittstelle
- Refillable Aluminum Trough
- Conformable Low-Bypass Seal
Produkteinführung
The FFU gel seal uses a continuous channel of stable silicone gel to receive the projecting knife edge of a mating HEPA filter or housing. As the knife edge enters the gel, the fluid conforms around minor dimensional variation without the compression load required by a foam gasket. An aluminum trough retains the gel around the full perimeter, with sealed corners and an optional fill port for controlled service. Trough dimensions, gel depth, viscosity and knife-edge immersion must match the installed filter system.
Key Features
A rigid aluminum trough controls gel depth and prevents migration from the sealing path.
Mitered or welded corner construction maintains channel continuity at perimeter turns.
A capped fill port supports controlled topping-up or replacement of compatible gel.
Kunden Produktbedenken
A fluid seal only performs reliably when the trough remains continuous and the mating knife edge reaches the correct gel depth.
Insufficient gel depth leaves sections of the knife edge unsealed.Trough volume and fill level are matched to the knife-edge height and intended immersion.
Corner discontinuities become bypass paths around an otherwise sealed perimeter.Sealed corner joints maintain one uninterrupted gel channel around the frame.
Incompatible gel hardens, flows or contaminates the mating surface.Gel chemistry and consistency are selected for the operating temperature and filter interface materials.
Overfilling causes gel displacement during filter installation.A defined trough profile and controlled refill quantity keep the gel below its retention lips.
Typische Anwendungen
Gel-seal FFU HEPA interfacesCleanroom terminal filter housingsPharmaceutical ceiling filter modulesLow-bypass filter replacement systems
Technische Parameter
Typical construction ranges for FFU fluid-gel seal troughs are shown below.
| Core Material | Non-curing silicone sealing gel retained in an aluminum perimeter trough |
|---|---|
| Panel Dicke | 15-40 mm nominal trough depth |
| Effektive Breite | 300-610 mm nominal frame width |
| Maximale Länge | Up to 1220 mm nominal frame length |
| Stahl facing Dicke | 0.8-1.5 mm optional stainless-steel cover or retaining component |
| Kerndichte | Approximately 950-1050 kg/m³ for the silicone gel |
| Thermische Leitfähigkeit | Approximately 0.15-0.25 W/(m·K) for silicone sealing gel |
| Oberfläche Finish | Natural silver aluminum trough with translucent blue or clear silicone gel |
| Gemeinsamer Typ | Continuous U-channel trough with sealed mitered corners and optional capped fill port |
| Customisierung | Verfügbar je nach beabsichtigter Anwendung und Betriebsumgebung. |
Verfügbare Optionen
Blue or clear compatible gelCustom trough dimensionsCapped fill and drain portsMatched knife-edge immersion depth
Planning a FFU Gel Seal specification?
Senden Sie uns Ihre Abmessungen, Installationsbedingungen, Leistungsziele und gewünschte Oberflächenveredelung.
