Cleanroom flexible air duct with silver vapor jacket and reinforced round bore

Sistemas de Distribuição de Ar para Sala Limpa

Ducto de ar flexível para sala limpa

A bendable reinforced air duct for short cleanroom terminal connections where rigid ductwork cannot absorb alignment or equipment movement.

Tight-Bend Connection
Spring-Wire Reinforcement
Smooth Flexible Liner
Insulated Option Available

Solicite um orçamento. Browse produtos

Introdução do produto

Cleanroom flexible duct uses a continuous polymer or coated-fabric liner supported by a corrosion-resistant spring-wire helix. It is intended for short final connections between rigid duct branches and diffusers, fan terminals or movable equipment, not as a substitute for long straight mains. An optional glass-fiber blanket and outer vapor jacket limit heat gain and condensation on conditioned-air runs. Correctly extended installation minimizes internal corrugation, while stainless clamps and foil tape secure each end to a smooth metal collar.

Características-chave

A spring-wire helix maintains the circular bore through controlled bends and minor alignment changes.

The continuous liner avoids longitudinal metal seams and accommodates equipment vibration.

Insulated versions combine a thermal blanket with a sealed external vapor jacket.

Short standard lengths discourage excessive sag and the pressure loss caused by compressed duct.

Preocupações do produto do cliente

Flexible duct only performs well when it is kept short, fully extended and supported without sharp kinks or compressed coils.

A rigid branch does not align precisely with the terminal collar.The flexible section absorbs the final offset without multiple hard elbows.

Compressed duct corrugations create unexpectedly high pressure loss.The liner is pulled taut and cut to the shortest practical connection length.

Unsupported duct sags above the ceiling and reduces its internal area.Wide straps at close intervals support the full diameter without pinching the jacket.

Cold-air connections sweat where the vapor jacket is punctured.Insulation and outer jacket are closed continuously around both collars with compatible tape.

Aplicações típicas

HEPA terminal-box connectionsCeiling diffuser branchesFan-powered terminal outletsVibration-isolated equipment linksShort return-air connections

Parâmetros técnicos

Typical construction ranges for reinforced flexible HVAC duct used at cleanroom terminals are shown below.

Material principal	Coated fiberglass fabric or multilayer polymer liner with corrosion-resistant spring-steel helix
Painel de espessura	0.10–0.30 mm flexible liner wall
Largura efetiva	75–500 mm nominal internal diameter
Comprimento máximo	7500 mm supplied length; short installed connections recommended
Aço enfrentando espessura	0.8–1.5 mm spring-wire diameter, depending on duct size
Densidade Core	16–24 kg/m³ optional glass-fiber insulation blanket
Condutividade térmica	0.036–0.043 W/(m·K) for insulated versions
Superfície acabado	Smooth inner liner with reinforced silver vapor-barrier outer jacket
Tipo conjunto	Clamped overlap on rigid collar with foil tape and sealed outer vapor jacket
Customização	Disponível com base na aplicação pretendida e no ambiente operacional.

Opções disponíveis

Uninsulated or insulated constructionR4.2, R6 or R8 thermal blanketLow-smoke polymer or coated-fabric linerStainless clamps and cleanroom-compatible sealing tape

Planning a Cleanroom Flexible Air Duct specification?

Envie-nos as suas dimensões, condições de instalação, metas de desempenho e acabamento de superfície necessário.

Fale com a nossa equipe