Negative-pressure powder dispensing isolator with integrated balance

Aliran Laminar dan Peralatan Pengekangan

Pengisolasi Dispensing Serbuk

A negative-pressure glovebox configured for closed powder weighing, subdivision and transfer with an isolated balance and contained waste route.

Closed Powder Dispensing
Isolated Balance Support
Negative-Pressure Chamber
Contained Material and Waste Ports

Permintaan sebut harga Semak imbas produk

Pengenalan Produk

This isolator encloses powder dispensing inside a welded stainless chamber. Operators work through glove ports, material enters through a transfer airlock or bag interface, and measured powder leaves through a sealed receiving connection. The balance sits on a structurally independent support to reduce blower and floor vibration. Negative chamber pressure and staged filtration keep airborne powder within the system, while empty packaging exits through a separate contained route.

Ciri-ciri Utama

A closed glovebox removes the open-front boundary from powder subdivision.

An isolated internal balance slab protects weighing stability.

Dedicated inlet and outlet interfaces separate source and receiving containers.

Negative pressure directs leakage inward toward staged filters.

A continuous liner or bag-out port contains empty packaging and cleaning waste.

Kebimbangan Produk Pelanggan

Closed dispensing must preserve accurate weighing while routing source material, product and waste through different contained interfaces.

Fan vibration causes unstable balance readings.An independent balance support passes through the isolator base without sharing the fan frame.

Source and receiving containers cross inside a small chamber.Separate inlet, dispensing and outlet positions create a one-way material sequence.

Empty liners carry residue into the room.A dedicated continuous-liner or bag-out port encloses packaging waste.

Powder remains at sharp internal joints.Welded radiused stainless transitions keep cleaning surfaces accessible.

Permohonan yang biasa

Potent powder dispensingAPI subdivisionContained sample weighingPre-weighed batch preparation

Parameter teknikal

Typical configurable construction ranges for a powder dispensing isolator are listed below.

Bahan Teras	Fully welded SUS316L negative-pressure chamber with safety glass, CSM gloves and an isolated balance support
Ketebalan Panel	50-100 mm double-skin chamber and filter sections
Lebar berkesan	1200-3000 mm usable dispensing width
Panjang maksimum	Up to 4500 mm overall isolator length
Keluli Menghadapi Ketebalan	2.0-3.0 mm SUS316L chamber shell; 1.2-1.5 mm service skins
Ketumpatan teras	Approximately 8000 kg/m³ for SUS316L chamber material
Kekonduksian Terma	14-16 W / (m · K) untuk keluli tahan karat austenit
Kemasan permukaan	Electropolished SUS316L with radiused corners and removable balance surround
Jenis Bersatu	Pressure-tight welded chamber with sealed glove rings, isolated balance penetration and contained transfer ports
Penyesuaian	Boleh didapati berdasarkan aplikasi yang dimaksudkan dan persekitaran operasi.

Pilihan yang boleh didapati

Continuous liner or split valveIntegrated drum or bag inletSafe-change filtersWash-in-place spray devices

Planning a Powder Dispensing Isolator specification?

Hantarkan kepada kami dimensi anda, syarat pemasangan, sasaran prestasi dan kemasan permukaan yang diperlukan.

Berbincang dengan pasukan kami