İngilizce
Almanca
Arapça
Fransızca
Endonezya dilinde
Japonca
Korece
Malay dilinde
Portekizce
Rusça
İspanyolca
Taylandca
TürkçeCurrent
Vietnamca
Hava filtreleri ve kimyasal filtrasyon
Eşit Basınç Filtresi Clamping Assembly
A stainless swing-bolt and bearing-bar mechanism that applies balanced compression to a filter gasket while moving clear for element removal.
- Uniform Gasket Compression
- Swing-Clear Service
- Tool-Controlled Adjustment
- Stainless Hardware
Ürün tanıtımı
This assembly secures box-style HEPA, ULPA or compact filters against a flat sealing flange. Threaded swing bolts pull a rigid equal-bearing bar toward the frame so the load is spread along the filter edge rather than concentrated at isolated clips. Captive pivots keep components attached during maintenance, and the bar swings or slides away from the opening when loosened. Stainless construction suits repeated use in clean and corrosive air systems.
Ana Özellikler
Threaded adjustment accommodates small differences in gasket and frame depth.
Captive pivots prevent loose hardware from falling into the air system.
The assembly moves outside the filter envelope for unrestricted removal.
Müşteri Ürün Sorunları
Uneven or improvised clamps can over-compress one gasket corner while leaving another side open to bypass.
Point clips leave low-pressure areas along a long filter edge.A rigid bearing bar distributes load over a wider sealing line.
Clamp parts are lost during overhead filter replacement.Captive bolts and pivots remain attached to the holding frame.
Different filter depths require new retaining hardware.Threaded travel allows the assembly to suit a defined range of frame and gasket heights.
The clamp blocks the filter as technicians pull it forward.Swing-clear geometry opens the complete removal path after release.
Tipik uygulamalar
Gasket-seal HEPA holding framesSide-access filter housingsBuilt-up absolute filter banksCleanroom terminal boxesIndustrial compact-filter racks
Teknik parametreler
Typical material and dimensional ranges for an equal-pressure filter clamp are shown below.
| Temel malzemeler | 304 stainless-steel swing bolts, pivots, equal-bearing bar and captive fasteners |
|---|---|
| Panel kalınlığı | 2.0–4.0 mm formed bearing bar and mounting plates |
| Effective Width (Etkili Genişlik) | 150–610 mm bearing length per filter edge |
| Maksimum uzunluk | Up to 650 mm overall clamp assembly length |
| Çelik yüz yüze kalınlığı | 2.0–4.0 mm stainless bearing and bracket components |
| Core Density (Çekirdek Yoğunluğu) | Approximately 8000 kg/m³ for 304 stainless-steel parts |
| Termal İletkenlik | Approximately 14–17 W/(m·K) for passivated stainless clamp hardware |
| Yüzey bitirme | Passivated stainless steel with smooth deburred edges |
| Ortak tip | Captive swing-bolt pivot with threaded compression adjustment and equal-bearing retainer |
| Customization (Özelleşme) | Kullanılan uygulama ve çalışma ortamına göre kullanılabilir. |
Mevcut Seçenekler
Single- or dual-bolt bearing barHand knob or tool-operated nutFrame-mounted or housing-mounted bracketAlternate travel for different filter depths
Planning a Equal-Pressure Filter Clamping Assembly specification?
Bize boyutlarınızı, montaj koşullarınızı, performans hedeflerinizi ve gerekli yüzey kaplamalarınızı gönderin.
