Three-quarter view of stainless equal-pressure filter clamping assembly

エアフィルターと化学ろ過

E 等圧フィルタークランプアセンブリ

A stainless swing-bolt and bearing-bar mechanism that applies balanced compression to a filter gasket while moving clear for element removal.

Uniform Gasket Compression
Swing-Clear Service
Tool-Controlled Adjustment
Stainless Hardware

見積もりリクエスト製品案内

商品紹介

This assembly secures box-style HEPA, ULPA or compact filters against a flat sealing flange. Threaded swing bolts pull a rigid equal-bearing bar toward the frame so the load is spread along the filter edge rather than concentrated at isolated clips. Captive pivots keep components attached during maintenance, and the bar swings or slides away from the opening when loosened. Stainless construction suits repeated use in clean and corrosive air systems.

主要な特徴

The bearing bar spreads clamp force along the filter edge.

Threaded adjustment accommodates small differences in gasket and frame depth.

Captive pivots prevent loose hardware from falling into the air system.

The assembly moves outside the filter envelope for unrestricted removal.

お客様の製品に関する懸念事項

Uneven or improvised clamps can over-compress one gasket corner while leaving another side open to bypass.

Point clips leave low-pressure areas along a long filter edge.A rigid bearing bar distributes load over a wider sealing line.

Clamp parts are lost during overhead filter replacement.Captive bolts and pivots remain attached to the holding frame.

Different filter depths require new retaining hardware.Threaded travel allows the assembly to suit a defined range of frame and gasket heights.

The clamp blocks the filter as technicians pull it forward.Swing-clear geometry opens the complete removal path after release.

典型的な用途

Gasket-seal HEPA holding framesSide-access filter housingsBuilt-up absolute filter banksCleanroom terminal boxesIndustrial compact-filter racks

技術的なパラメータ

Typical material and dimensional ranges for an equal-pressure filter clamp are shown below.

コア材料	304 stainless-steel swing bolts, pivots, equal-bearing bar and captive fasteners
パネルの厚さ	2.0–4.0 mm formed bearing bar and mounting plates
有効幅	150–610 mm bearing length per filter edge
最大長さ	Up to 650 mm overall clamp assembly length
鋼鉄の厚さを直面する	2.0–4.0 mm stainless bearing and bracket components
コア密度	Approximately 8000 kg/m³ for 304 stainless-steel parts
熱伝導率	Approximately 14–17 W/(m·K) for passivated stainless clamp hardware
表面仕上げ	Passivated stainless steel with smooth deburred edges
ジョイントタイプ	Captive swing-bolt pivot with threaded compression adjustment and equal-bearing retainer
カスタマイズ	意図したアプリケーションと動作環境に基づいて利用できます。

利用可能なオプション

Single- or dual-bolt bearing barHand knob or tool-operated nutFrame-mounted or housing-mounted bracketAlternate travel for different filter depths

Planning a Equal-Pressure Filter Clamping Assembly specification?

寸法、設置条件、性能目標、必要な表面仕上げをお送りください。

チームに相談する