Three-quarter view of stainless equal-pressure filter clamping assembly

Filter udara dan filtrasi kimia

Perhimpunan Filter Clamping dengan Tekanan yang Sama

A stainless swing-bolt and bearing-bar mechanism that applies balanced compression to a filter gasket while moving clear for element removal.

Uniform Gasket Compression
Swing-Clear Service
Tool-Controlled Adjustment
Stainless Hardware

Permintaan untuk kutipan Browse Produk

Perkenalan produk

This assembly secures box-style HEPA, ULPA or compact filters against a flat sealing flange. Threaded swing bolts pull a rigid equal-bearing bar toward the frame so the load is spread along the filter edge rather than concentrated at isolated clips. Captive pivots keep components attached during maintenance, and the bar swings or slides away from the opening when loosened. Stainless construction suits repeated use in clean and corrosive air systems.

Fitur utama:

The bearing bar spreads clamp force along the filter edge.

Threaded adjustment accommodates small differences in gasket and frame depth.

Captive pivots prevent loose hardware from falling into the air system.

The assembly moves outside the filter envelope for unrestricted removal.

Kekhawatiran produk pelanggan

Uneven or improvised clamps can over-compress one gasket corner while leaving another side open to bypass.

Point clips leave low-pressure areas along a long filter edge.A rigid bearing bar distributes load over a wider sealing line.

Clamp parts are lost during overhead filter replacement.Captive bolts and pivots remain attached to the holding frame.

Different filter depths require new retaining hardware.Threaded travel allows the assembly to suit a defined range of frame and gasket heights.

The clamp blocks the filter as technicians pull it forward.Swing-clear geometry opens the complete removal path after release.

Aplikasi yang Tipis

Gasket-seal HEPA holding framesSide-access filter housingsBuilt-up absolute filter banksCleanroom terminal boxesIndustrial compact-filter racks

Parameter teknis

Typical material and dimensional ranges for an equal-pressure filter clamp are shown below.

Bahan inti	304 stainless-steel swing bolts, pivots, equal-bearing bar and captive fasteners
Ketebalan Panel (Panel Thickness)	2.0–4.0 mm formed bearing bar and mounting plates
Efektif lebar	150–610 mm bearing length per filter edge
Panjang maksimum	Up to 650 mm overall clamp assembly length
Baja menghadap ketebalan	2.0–4.0 mm stainless bearing and bracket components
Kepadatan inti (core density)	Approximately 8000 kg/m³ for 304 stainless-steel parts
Konduktivitas Termal (Thermal Conductivity)	Approximately 14–17 W/(m·K) for passivated stainless clamp hardware
Permukaan selesai	Passivated stainless steel with smooth deburred edges
Jenis Bersama	Captive swing-bolt pivot with threaded compression adjustment and equal-bearing retainer
Customization (Kustomisasi)	Tersedia berdasarkan aplikasi yang dimaksudkan dan lingkungan operasi.

Pilihan yang tersedia

Single- or dual-bolt bearing barHand knob or tool-operated nutFrame-mounted or housing-mounted bracketAlternate travel for different filter depths

Planning a Equal-Pressure Filter Clamping Assembly specification?

Kirimkan kami dimensi Anda, kondisi instalasi, target kinerja dan permukaan akhir yang diperlukan.

Bicaralah dengan tim kami