English
Немецкий
Арабский язык
Французский
Индонезийский
Японский язык
Корейский
Японский
Португальский
Русский языкТекущий
Испанский язык
Тайский
Турецкий
Вьетнамский язык
Запчасти для оборудования для чистых помещений
FFU Speed Controller
A compact panel-mounted controller that gives operators direct, stepless airflow adjustment for compatible EC-motor fan filter units.
- Stepless Manual Adjustment
- EC Fan Signal Control
- Compact Panel Mounting
- Serviceable Screw Terminals
Введение продукции
The FFU speed controller provides a local setpoint for a compatible electronically commutated fan motor. Turning the front potentiometer varies the low-voltage command used by the motor electronics, allowing commissioning or maintenance personnel to trim airflow without replacing the FFU drive. The molded enclosure protects the control components, while mounting ears and a removable screw terminal block simplify installation near the fan housing or inside a control compartment. Signal range, terminal assignment and minimum-speed behavior must be matched to the existing motor or FFU control card.
Основные характеристики
Low-voltage signal architecture is suited to EC fans that accept an analog speed command.
Front status indication provides a quick visual check that the control circuit is energized.
Screw terminals and external mounting tabs support straightforward replacement and servicing.
Обеспокоенность клиентов продуктами
A replacement speed controller must produce the signal expected by the installed motor and fit the existing wiring and mounting arrangement.
The new controller uses a signal range that the existing EC motor cannot interpret correctly.The controller is selected to match the motor's specified analog command range and reference supply.
Airflow falls below the stable operating point at the lowest dial position.Minimum-speed behavior can be matched or preset to preserve the required lower airflow limit.
Different terminal assignments create wiring errors during field replacement.Terminal count, signal common, reference voltage and command output are verified against the original connection diagram.
The control cannot be secured near the FFU without modifying the housing.Mounting-tab geometry and enclosure orientation can be configured for the available service space.
Типичные приложения
Single FFU airflow commissioningCleanroom ceiling fan filter unitsLaminar-flow workstation fansLocal EC fan maintenance control
Технические параметры
Typical construction ranges for compact manual FFU speed controllers are shown below.
| Основной материал | Flame-retardant PC/ABS enclosure with FR-4 control board and copper-alloy terminals |
|---|---|
| Толщина панели | 35-70 mm nominal enclosure depth |
| эффективная ширина | 70-135 mm nominal mounting width |
| Максимальная длина | Up to 160 mm overall length including mounting tabs |
| Толщина линий стали | 0.8-1.5 mm equivalent terminal-clamp and internal bracket thickness |
| Плотность ядра | 1050-1250 kg/m³ for molded PC/ABS enclosure material |
| Теплопроводимость | 0.18-0.25 W/(m·K) for molded enclosure material |
| Поверхностная отделка | Fine-textured matte-black housing with white dial marks, green indicator and green terminal block |
| Объединенный тип | Six-position screw terminal connection with bolted external mounting tabs |
| Customization | Доступно в зависимости от предполагаемого применения и операционной среды. |
Доступные варианты
0-10 V or matched potentiometer interfaceMinimum-speed presetAlternative terminal assignmentCustom mounting-tab geometry
Planning a FFU Speed Controller specification?
Отправьте нам ваши габариты, условия монтажа, целевые показатели производительности и требуемую отделку поверхности.
