Direct-expansion cooling coil with blue fins and copper distributor

ОВК и оборудование для обработки воздуха в чистых помещениях

Пряморасширяющая охлаждающая катушка

A direct-expansion evaporator coil that boils refrigerant inside multiple copper circuits to cool and dehumidify cleanroom air.

Multi-Circuit Refrigerant Distribution
Direct Evaporative Cooling
Large Suction Header
Matched Condensing Unit Service

Запрос котировки Просмотреть продукты

Введение продукции

Liquid refrigerant enters a brass distributor and divides through small feeder tubes into multiple copper circuits. It evaporates as air crosses the fin pack, then returns through a large suction header to the remote condensing unit. Distributor sizing, circuit length and coil orientation are coordinated to keep all rows active across the expected load range and to return oil reliably.

Основные характеристики

A precision distributor divides two-phase refrigerant among equalized evaporator circuits.

Copper circuits and aluminum fins provide direct sensible and latent cooling without a secondary water loop.

A large suction header collects vapor at controlled velocity for stable superheat and oil return.

Independent or intertwined circuits can support staged compressors and part-load face coverage.

Обеспокоенность клиентов продуктами

DX coils depend on uniform refrigerant distribution and correctly matched circuits to prevent starving, flooding and temperature streaks.

Unequal feeder flow leaves some coil circuits inactive.A matched distributor and equal-length feeder tubes divide refrigerant across every circuit.

Low load causes unstable superheat and liquid carryover.Staged or intertwined circuits preserve active face area and stable expansion-valve control.

Long suction runs fail to return compressor oil.Header diameter, circuit velocity and piping traps are selected around the remote condensing unit.

Condensate carryover wets downstream filters.Coil face velocity, fin treatment and drain-pan geometry are coordinated for complete drainage.

Типичные приложения

Remote-DX cleanroom air handlersPackaged make-up air unitsLaboratory environmental chambersMedical manufacturing HVACDedicated humidity-control systems

Технические параметры

Representative construction ranges for a multi-circuit cleanroom DX evaporator coil are listed below.

Основной материал	C12200 copper refrigerant tubes with aluminum fins, brass distributor and copper suction header
Толщина панели	1.5-2.0 mm galvanized or stainless casing
эффективная ширина	400-2800 mm active fin face width
Максимальная длина	Up to 4000 mm overall coil casing length
Толщина линий стали	1.0-1.5 mm stainless drain pan where supplied
Плотность ядра	Approximately 8940 kg/m³ for the C12200 copper refrigerant-tube circuit
Теплопроводимость	Approximately 339 W/(m·K) for the C12200 copper DX refrigerant tubes at room temperature
Поверхностная отделка	Natural, blue hydrophilic or epoxy-coated aluminum fins
Объединенный тип	Brazed copper refrigerant circuits with flared or brazed distributor and suction connections
Customization	Доступно в зависимости от предполагаемого применения и операционной среды.

Доступные варианты

Single, staged or intertwined refrigerant circuitsDifferent tube diameters and row countsHydrophilic or epoxy-coated finsStainless casing, drain pan and moisture eliminator

Planning a Direct-Expansion Cooling Coil specification?

Отправьте нам ваши габариты, условия монтажа, целевые показатели производительности и требуемую отделку поверхности.

Поговорите с нашей командой