Inglês
Alemão
Língua árabe
Francês
Língua indonésia
Japonês
Coreano
Língua malaia
Portuguêsatual
Língua russa
Espanhol
Tailandês
Língua turca
Vietnã
Sistemas de Distribuição de Ar para Sala Limpa
Diffusor de ar perfurado face
A ceiling diffuser with a fully perforated removable face that equalizes discharge over the panel area for gentle vertical or low-turbulence supply air.
- Uniform Perforated Face
- Low-Turbulence Discharge
- Pressure-Equalizing Plenum
- Tool-Free Face Access
Introdução do produto
The perforated face air diffuser slows supply air in a rear plenum and releases it through hundreds of evenly distributed openings rather than a few concentrated slots. An internal equalizer or distribution plate reduces high velocity directly below the duct inlet, helping the full visible face remain active. The flat powder-coated panel sits flush with a modular cleanroom ceiling and can be released from below for cleaning. Supply and extract variants use the same restrained appearance, allowing coordinated terminal layouts in controlled rooms.
Características-chave
The rear equalizer limits the central hot spot normally produced by a direct top duct connection.
A flat removable panel leaves no deep vanes that trap lint at the room face.
Matching supply and extract configurations maintain a consistent ceiling appearance.
Preocupações do produto do cliente
Perforated diffusers only work uniformly when the plenum removes inlet momentum and the complete face remains clean and unobstructed.
Most airflow exits through the holes directly under the inlet spigot.A distribution screen and sufficient plenum depth spread static pressure across the rear of the face.
Small perforations retain surface dust that is difficult to wipe from a fixed panel.A detachable face can be washed or wiped from both sides away from the ceiling frame.
Sharp perforation burrs disrupt cleaning cloths and create particle traps.Deburred punched holes and a continuous powder coating produce a smooth cleanable surface.
Uneven ceiling framing bows the panel and opens perimeter gaps.A rigid return-edge frame supports the face while a compressible gasket follows the ceiling plane.
Aplicações típicas
Low-turbulence cleanroom supplyHospital clean treatment roomsLaboratory preparation spacesPharmaceutical weighing support roomsClean corridor and change-area ceilings
Parâmetros técnicos
Typical construction ranges for a cleanroom perforated-face ceiling diffuser are listed below.
| Material principal | Deburred perforated steel face with galvanized pressure-equalizing plenum and internal distribution plate |
|---|---|
| Painel de espessura | 0.8–1.2 mm perforated face and plenum sheet |
| Largura efetiva | 300–600 mm nominal active face width |
| Comprimento máximo | Up to 1200 mm for rectangular perforated modules |
| Aço enfrentando espessura | 0.8–1.2 mm punched steel face panel |
| Densidade Core | Approximately 7850 kg/m³ for the steel perforated face and equalizer |
| Condutividade térmica | Approximately 45–60 W/(m·K) for the steel perforated face and equalizer |
| Superfície acabado | White epoxy-polyester powder coat over fully deburred steel, with stainless option |
| Tipo conjunto | Flush gasketed frame with hinged or lift-out perforated face and sealed plenum spigot |
| Customização | Disponível com base na aplicação pretendida e no ambiente operacional. |
Opções disponíveis
Vertical low-turbulence or horizontal spread equalizerSupply or extract configuration304 stainless-steel perforated faceSquare or rectangular ceiling module
Planning a Perforated Face Air Diffuser specification?
Envie-nos as suas dimensões, condições de instalação, metas de desempenho e acabamento de superfície necessário.
