Square perforated face air diffuser with white cleanroom ceiling frame

クリーンルーム空気分配システム

穿孔した顔空気拡散器

A ceiling diffuser with a fully perforated removable face that equalizes discharge over the panel area for gentle vertical or low-turbulence supply air.

Uniform Perforated Face
Low-Turbulence Discharge
Pressure-Equalizing Plenum
Tool-Free Face Access

見積もりリクエスト製品案内

商品紹介

The perforated face air diffuser slows supply air in a rear plenum and releases it through hundreds of evenly distributed openings rather than a few concentrated slots. An internal equalizer or distribution plate reduces high velocity directly below the duct inlet, helping the full visible face remain active. The flat powder-coated panel sits flush with a modular cleanroom ceiling and can be released from below for cleaning. Supply and extract variants use the same restrained appearance, allowing coordinated terminal layouts in controlled rooms.

主要な特徴

A high open-area perforation pattern divides the air stream into many low-momentum jets across the complete panel.

The rear equalizer limits the central hot spot normally produced by a direct top duct connection.

A flat removable panel leaves no deep vanes that trap lint at the room face.

Matching supply and extract configurations maintain a consistent ceiling appearance.

お客様の製品に関する懸念事項

Perforated diffusers only work uniformly when the plenum removes inlet momentum and the complete face remains clean and unobstructed.

Most airflow exits through the holes directly under the inlet spigot.A distribution screen and sufficient plenum depth spread static pressure across the rear of the face.

Small perforations retain surface dust that is difficult to wipe from a fixed panel.A detachable face can be washed or wiped from both sides away from the ceiling frame.

Sharp perforation burrs disrupt cleaning cloths and create particle traps.Deburred punched holes and a continuous powder coating produce a smooth cleanable surface.

Uneven ceiling framing bows the panel and opens perimeter gaps.A rigid return-edge frame supports the face while a compressible gasket follows the ceiling plane.

典型的な用途

Low-turbulence cleanroom supplyHospital clean treatment roomsLaboratory preparation spacesPharmaceutical weighing support roomsClean corridor and change-area ceilings

技術的なパラメータ

Typical construction ranges for a cleanroom perforated-face ceiling diffuser are listed below.

コア材料	Deburred perforated steel face with galvanized pressure-equalizing plenum and internal distribution plate
パネルの厚さ	0.8–1.2 mm perforated face and plenum sheet
有効幅	300–600 mm nominal active face width
最大長さ	Up to 1200 mm for rectangular perforated modules
鋼鉄の厚さを直面する	0.8–1.2 mm punched steel face panel
コア密度	Approximately 7850 kg/m³ for the steel perforated face and equalizer
熱伝導率	Approximately 45–60 W/(m·K) for the steel perforated face and equalizer
表面仕上げ	White epoxy-polyester powder coat over fully deburred steel, with stainless option
ジョイントタイプ	Flush gasketed frame with hinged or lift-out perforated face and sealed plenum spigot
カスタマイズ	意図したアプリケーションと動作環境に基づいて利用できます。

利用可能なオプション

Vertical low-turbulence or horizontal spread equalizerSupply or extract configuration304 stainless-steel perforated faceSquare or rectangular ceiling module

Planning a Perforated Face Air Diffuser specification?

寸法、設置条件、性能目標、必要な表面仕上げをお送りください。

チームに相談する