Inglês
Alemão
Língua árabe
Francês
Língua indonésia
Japonês
Coreano
Língua malaia
Portuguêsatual
Língua russa
Espanhol
Tailandês
Língua turca
Vietnã
Filtros de ar e filtragem química
Canal de vedação de gel de filtro HEPA
A continuous aluminum channel filled with soft silicone gel that accepts a housing knife edge to form a conformable HEPA or ULPA perimeter seal.
- Resealable Silicone Gel
- Continuous Perimeter Channel
- Knife-Edge Interface
- Low Compression Force
Introdução do produto
The gel seal is a U-shaped channel integrated into the downstream face of a HEPA or ULPA frame. A non-flowing silicone compound fills the channel and surrounds the terminal or holding-frame knife edge when the filter is clamped into place. Unlike a flat foam gasket, the gel conforms around small surface irregularities with limited compression travel. The channel is closed at the corners to keep gel depth continuous across the full perimeter.
Características-chave
A rigid aluminum channel controls gel depth and prevents edge spread.
The seal can accept repeated knife-edge insertion when the gel surface remains clean and intact.
Corner joints are sealed to maintain one continuous perimeter reservoir.
Preocupações do produto do cliente
A terminal filter needs a low-bypass seal within limited clamp travel and around small knife-edge irregularities.
A flat gasket does not conform to a slightly uneven knife edge.Soft gel displaces around the edge and maintains contact along both sides.
Excess gel escapes when the filter is inverted for installation.A thixotropic non-flowing formulation remains inside the enclosed channel.
An open corner creates a direct bypass route.Mitered and sealed channel corners preserve the continuous gel reservoir.
Deep knife-edge insertion bottoms against the aluminum channel.Specified gel depth and clamp stop keep the metal edge within the soft sealing zone.
Aplicações típicas
Cleanroom terminal HEPA filtersULPA ceiling modulesGel-seal holding framesFan filter unitsLow-bypass final filter banks
Parâmetros técnicos
Representative construction ranges for a HEPA gel-seal channel are listed below.
| Material principal | Non-flowing two-component silicone gel in an extruded aluminum U-channel |
|---|---|
| Painel de espessura | 10–18 mm filled channel depth |
| Largura efetiva | 12–25 mm gel channel width |
| Comprimento máximo | Up to 1220 mm per continuous filter-frame side |
| Aço enfrentando espessura | 0.8–1.5 mm equivalent aluminum channel wall thickness |
| Densidade Core | 850–1050 kg/m³ cured silicone gel density |
| Condutividade térmica | 0.15–0.25 W/(m·K) for cured silicone gel |
| Superfície acabado | Natural anodized aluminum channel with translucent blue silicone gel |
| Tipo conjunto | Continuous closed-corner gel channel mating with a stainless or coated-steel knife edge |
| Customização | Disponível com base na aplicação pretendida e no ambiente operacional. |
Opções disponíveis
Blue or clear silicone gelDifferent channel depthsAluminum or stainless perimeter channelFactory-filled replacement frame
Planning a HEPA Filter Gel Seal Channel specification?
Envie-nos as suas dimensões, condições de instalação, metas de desempenho e acabamento de superfície necessário.
