Three-quarter view of a galvanized four-way cleanroom ceiling grid connector

클린룸 설치 액세서리

천장 그리드 커넥터

A galvanized four-way stamped plate that locates and fastens intersecting cleanroom ceiling-grid channels at a common center.

Four-Way Geometry
Eight Adjustment Slots
Folded Locating Tabs
Galvanized Steel

견적 요청 제품 찾아보기

상품 소개

The ceiling grid connector is a one-piece stamped steel cross plate with four perpendicular arms. Paired oblong slots on every arm provide fixing and limited alignment adjustment, while folded tabs register mating channels around the central intersection. The low-profile fitting reinforces a four-way ceiling-grid joint without adding a bulky exposed component below the finished ceiling plane.

주요 기능

Four equal arms establish a controlled orthogonal grid intersection.

Two slots per arm provide balanced fixing and field adjustment.

Folded locating tabs guide compatible channels into repeatable positions.

Stamped galvanized construction combines low profile with practical joint stiffness.

고객 제품 관심사

Four intersecting ceiling channels must remain square and flush while installers position and tighten multiple fasteners.

Loose channels drift out of square during assembly.The cross geometry and locating tabs register all four directions from one center.

Fixed round holes offer little tolerance for site alignment.Paired elongated slots provide controlled adjustment before tightening.

Stacked splice pieces create an uneven joint thickness.A single stamped plate distributes the connection in one low-profile layer.

Unprotected concealed steel can corrode in humid plenums.Galvanized or stainless material is selected for the expected exposure.

일반적인 응용 프로그램

Cleanroom ceiling-grid intersectionsModular ceiling framesService-plenum support gridsWalkable ceiling subframesFour-way channel junctions

기술 매개변수

Typical construction ranges for a four-way galvanized cleanroom ceiling-grid connector are listed below.

핵심 재료	One-piece stamped galvanized carbon-steel cross connector
패널 두께	40-150 mm compatible ceiling-panel thickness
유효 폭	30-100 mm compatible grid-channel width per arm
최대 길이	Up to 500 mm overall connector span
강철 면면 두께	1.50-3.00 mm stamped connector thickness
코어 밀도	Approximately 7850 kg/m³ for carbon steel
열전도도 (Thermal Conductivity)	Approximately 45-60 W/(m·K) for carbon steel
표면 마무리	Silver zinc-plated or hot-dip galvanized stamped steel
접합 유형	Four-way slotted overlap connection with folded channel-locating tabs
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

사용 가능한 옵션

Galvanized or stainless steelCustom arm lengthRound or elongated fixing holesChannel-specific locating-tab geometry

Planning a Ceiling Grid Connector specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.