Makeup air unit with outdoor intake and tempered supply sections

クリーンルーム HVAC および空気処理装置

メイクアップ空気ユニット

A dedicated outdoor-air unit that replaces exhausted process air and maintains the intended cleanroom pressure relationship.

Exhaust Air Replacement
Pressure Cascade Support
Tempered Outdoor Supply
Airflow Tracking Control

見積もりリクエスト製品案内

商品紹介

The makeup air unit delivers conditioned outside air in proportion to fume-hood, process, canopy or room exhaust. Unlike a general fresh-air unit, its primary control duty is mass-balance: supply airflow must respond predictably as exhaust devices start, stop or modulate. Filters, coils and optional humidity treatment bring the outdoor air to a condition that the room or recirculation system can accept without upsetting temperature and moisture control. A low-leakage casing and fast fan response help prevent door forces and unwanted infiltration.

主要な特徴

Supply airflow can track a combined exhaust-air signal rather than operate at one fixed ventilation rate.

Tempering coils prevent replacement air from imposing abrupt heating, cooling or moisture loads on the cleanroom.

Fast variable-speed fan control supports stable room pressure during process exhaust transitions.

Separate intake filtration prevents outdoor particles from entering through uncontrolled building leakage paths.

お客様の製品に関する懸念事項

A facility can have sufficient cooling capacity yet still lose pressure control when exhaust and replacement air do not change together.

Starting a process exhaust fan pulls adjacent cleanrooms below their pressure setpoint.The makeup fan follows the combined exhaust airflow signal with a configured offset for pressure cascade.

Untempered winter replacement air causes cold drafts and local condensation.Preheat and final heating stages deliver supply air at a controlled temperature.

Outdoor humidity overwhelms the room AHU during high exhaust operation.Cooling and dehumidification are sized for the full makeup-air latent load.

Unfiltered infiltration enters around doors when replacement air is insufficient.Measured makeup volume enters through staged filters and a defined supply path.

典型的な用途

Pharmaceutical process exhaust replacementLaboratory fume-hood makeup airClean manufacturing canopy exhaustChemical handling roomsHospital isolation support areas

技術的なパラメータ

Representative makeup-air unit casing and connection ranges are provided below.

コア材料	Closed-cell polyurethane or mineral-wool insulation within double-wall casing
パネルの厚さ	50–60 mm insulated panel
有効幅	800–3000 mm nominal casing width
最大長さ	Up to 9000 mm with staged filtration and thermal treatment
鋼鉄の厚さを直面する	0.6–1.0 mm sheet steel casing skins
コア密度	40–43 kg/m³ polyurethane or 80–96 kg/m³ mineral wool
熱伝導率	0.022–0.040 W/(m·K) according to insulation selection
表面仕上げ	Powder-coated galvanized exterior with galvanized or stainless wet-section interior
ジョイントタイプ	Thermal-break frame and gasketed block joints with flexible supply-duct connector
カスタマイズ	意図したアプリケーションと動作環境に基づいて利用できます。

利用可能なオプション

Exhaust-airflow or room-pressure trackingGas, steam, hot-water or electric heatingChilled-water, DX or desiccant dehumidificationOutdoor roof, floor or plant-room arrangement

Planning a Makeup Air Unit specification?

寸法、設置条件、性能目標、必要な表面仕上げをお送りください。

チームに相談する