Englisch
DeutschCurrent
Arabisch
Französisch
indonesisch
Japanisch
Koreanisch
Malaiisch
Portugiesisch
Russisch
Spanisch
Thailändisch
Türkischer Sprache
Vietnamesisch
Reinraum HVAC und Luftbehandlung Ausrüstung
Make-up Air Unit
A dedicated outdoor-air unit that replaces exhausted process air and maintains the intended cleanroom pressure relationship.
- Exhaust Air Replacement
- Pressure Cascade Support
- Tempered Outdoor Supply
- Airflow Tracking Control
Produkteinführung
The makeup air unit delivers conditioned outside air in proportion to fume-hood, process, canopy or room exhaust. Unlike a general fresh-air unit, its primary control duty is mass-balance: supply airflow must respond predictably as exhaust devices start, stop or modulate. Filters, coils and optional humidity treatment bring the outdoor air to a condition that the room or recirculation system can accept without upsetting temperature and moisture control. A low-leakage casing and fast fan response help prevent door forces and unwanted infiltration.
Key Features
Tempering coils prevent replacement air from imposing abrupt heating, cooling or moisture loads on the cleanroom.
Fast variable-speed fan control supports stable room pressure during process exhaust transitions.
Separate intake filtration prevents outdoor particles from entering through uncontrolled building leakage paths.
Kunden Produktbedenken
A facility can have sufficient cooling capacity yet still lose pressure control when exhaust and replacement air do not change together.
Starting a process exhaust fan pulls adjacent cleanrooms below their pressure setpoint.The makeup fan follows the combined exhaust airflow signal with a configured offset for pressure cascade.
Untempered winter replacement air causes cold drafts and local condensation.Preheat and final heating stages deliver supply air at a controlled temperature.
Outdoor humidity overwhelms the room AHU during high exhaust operation.Cooling and dehumidification are sized for the full makeup-air latent load.
Unfiltered infiltration enters around doors when replacement air is insufficient.Measured makeup volume enters through staged filters and a defined supply path.
Typische Anwendungen
Pharmaceutical process exhaust replacementLaboratory fume-hood makeup airClean manufacturing canopy exhaustChemical handling roomsHospital isolation support areas
Technische Parameter
Representative makeup-air unit casing and connection ranges are provided below.
| Core Material | Closed-cell polyurethane or mineral-wool insulation within double-wall casing |
|---|---|
| Panel Dicke | 50–60 mm insulated panel |
| Effektive Breite | 800–3000 mm nominal casing width |
| Maximale Länge | Up to 9000 mm with staged filtration and thermal treatment |
| Stahl facing Dicke | 0.6–1.0 mm sheet steel casing skins |
| Kerndichte | 40–43 kg/m³ polyurethane or 80–96 kg/m³ mineral wool |
| Thermische Leitfähigkeit | 0.022–0.040 W/(m·K) according to insulation selection |
| Oberfläche Finish | Powder-coated galvanized exterior with galvanized or stainless wet-section interior |
| Gemeinsamer Typ | Thermal-break frame and gasketed block joints with flexible supply-duct connector |
| Customisierung | Verfügbar je nach beabsichtigter Anwendung und Betriebsumgebung. |
Verfügbare Optionen
Exhaust-airflow or room-pressure trackingGas, steam, hot-water or electric heatingChilled-water, DX or desiccant dehumidificationOutdoor roof, floor or plant-room arrangement
Planning a Makeup Air Unit specification?
Senden Sie uns Ihre Abmessungen, Installationsbedingungen, Leistungsziele und gewünschte Oberflächenveredelung.
