Embossed aluminum insulation jacketing roll for HVAC duct protection

Sistem Distribusi Udara Cleanroom

Aluminium Insulation Jacketing Aluminium Insulation Jacketing Aluminium Insulation Jacketing

A formed aluminum outer cladding that protects duct insulation from impact, weather and maintenance traffic while preserving a clean metallic finish.

Durable Aluminum Protection
Moisture-Barrier Backing
Smooth or Embossed Finish
Formed for Ducts and Fittings

Permintaan untuk kutipan Browse Produk

Perkenalan produk

Aluminum insulation jacketing forms the outer mechanical and weather protection over insulated ductwork. Flat sheet or coil is cut and formed around rectangular ducts, round ducts, elbows and equipment casings with overlapped seams oriented to shed water. A factory-applied polyethylene moisture barrier separates the metal jacket from wet insulation and reduces galvanic contact. Smooth, stucco-embossed or corrugated finishes are available, and banding or sealed sheet-metal fasteners secure the cladding without crushing the insulation beneath.

Fitur utama:

Lightweight aluminum protects soft insulation against tears, impact and routine maintenance contact.

Polyfilm backing separates the jacket from retained moisture and dissimilar metal surfaces.

Stucco embossing disguises minor handling marks and increases sheet stiffness.

Purpose-formed closures maintain coverage around elbows, access doors and irregular fittings.

Kekhawatiran produk pelanggan

Protective cladding must keep water out without puncturing the vapor barrier or compressing the insulation it is intended to protect.

Maintenance activity tears exposed foil-faced insulation.Rigid aluminum cladding provides a sacrificial impact-resistant outer surface.

Rain enters upward-facing laps on an outdoor duct.Shingle-oriented overlaps and sealed top seams direct water away from the insulation.

Condensate trapped against bare aluminum causes corrosion staining.A factory-applied polyfilm moisture barrier isolates the underside of the jacket.

Tight bands compress insulation and create thermal bridges.Correctly spaced banding secures the jacket while preserving the designed insulation thickness.

Aplikasi yang Tipis

Outdoor insulated air ductsMechanical-room ductworkCleanroom ceiling service zonesProcess exhaust insulation protectionInsulated plenums and fittings

Parameter teknis

Typical material ranges for aluminum jacketing used over HVAC duct insulation are shown below.

Bahan inti	3003 or 3105 aluminum alloy sheet with optional polyfilm moisture barrier
Ketebalan Panel (Panel Thickness)	0.4–1.0 mm aluminum cladding
Efektif lebar	1000–1200 mm coil or sheet width
Panjang maksimum	3000 mm sheet length or continuous coil supply
Baja menghadap ketebalan	0.4–1.0 mm aluminum jacket in place of steel facing
Kepadatan inti (core density)	Approximately 2700 kg/m³ solid aluminum
Konduktivitas Termal (Thermal Conductivity)	Approximately 160–200 W/(m·K) for aluminum jacketing alloy
Permukaan selesai	Smooth, stucco-embossed or corrugated mill-finish aluminum
Jenis Bersama	Overlapped weather-shedding seam with bands, rivets or sealed sheet-metal screws
Customization (Kustomisasi)	Tersedia berdasarkan aplikasi yang dimaksudkan dan lingkungan operasi.

Pilihan yang tersedia

Smooth or stucco-embossed finishPolyfilm moisture-barrier backingAluminum or stainless bandingPreformed elbow and access-door covers

Planning a Aluminum Insulation Jacketing specification?

Kirimkan kami dimensi Anda, kondisi instalasi, target kinerja dan permukaan akhir yang diperlukan.

Bicaralah dengan tim kami