Long white linear slot air diffuser with adjustable black deflection vanes

Системы распределения воздуха в чистых помещениях

Дифузер воздуха с линейным слотом

An extruded aluminum one- to six-slot diffuser that forms an adjustable horizontal or vertical plane jet along cleanroom ceilings and walls.

One to Six Linear Slots
Adjustable Plane Jet
Continuous Run Alignment
Detachable Extruded Core

Запрос котировки Просмотреть продукты

Введение продукции

The linear slot air diffuser provides a narrow architectural outlet where long, controlled plane jets are preferred to square ceiling terminals. Extruded aluminum frames maintain straight slot edges, and paired internal deflection vanes rotate to direct air along the ceiling, down a wall or into the room. Individual lengths connect with alignment strips to form continuous visual runs. The removable core exposes the balancing module and plenum for cleaning without disturbing the finished ceiling border.

Основные характеристики

Paired aluminum deflection vanes redirect the plane jet without changing the visible slot width.

Extruded frame sections hold a straight consistent line through individual and continuous-run installations.

One- to six-slot configurations cover different airflow duties without changing the product family appearance.

The complete slot core detaches to reach the plenum, adjustment module and downstream duct surface.

Обеспокоенность клиентов продуктами

A continuous slot system must maintain a straight appearance and consistent throw along its full length while preserving access to concealed balancing components.

Adjacent diffuser sections show visible steps or changing slot width.Rigid extrusions and internal alignment strips hold modular sections on one continuous centerline.

Supply air detaches from the ceiling when branch airflow is reduced.Profiled deflection vanes preserve a controlled Coanda jet over a broad operating range.

The plenum damper cannot be reached after the ceiling is closed.A detachable core provides room-side access to the measuring and adjustment module.

A single inlet leaves one end of a long slot under-supplied.Long sections use multiple gasketed spigots and a full-length plenum to equalize pressure.

Типичные приложения

Cleanroom perimeter air distributionLong pharmaceutical corridorsLaboratory ceiling and wall supplyClean office glazing zonesContinuous exhaust slots above process support areas

Технические параметры

Typical construction data for a cleanroom linear slot diffuser and matching plenum are listed below.

Основной материал	Extruded aluminum frame and deflection vanes with galvanized-steel balancing plenum
Толщина панели	1.2–2.0 mm aluminum extrusion wall thickness
эффективная ширина	38–250 mm nominal face width for one to six slots
Максимальная длина	Up to 2000 mm per section with aligned continuous runs
Толщина линий стали	0.8–1.0 mm galvanized-steel plenum casing
Плотность ядра	Approximately 2700 kg/m³ for the extruded aluminum diffuser components
Теплопроводимость	Approximately 200–210 W/(m·K) for the extruded aluminum diffuser components
Поверхностная отделка	White epoxy-polyester powder coat or clear anodized aluminum
Объединенный тип	Alignment-strip section joints with concealed frame fixing and gasketed round plenum spigots
Customization	Доступно в зависимости от предполагаемого применения и операционной среды.

Доступные варианты

One to six active slotsStandard, narrow or concealed border frameSupply, extract or filtered-extract plenumSingle lengths or aligned continuous runs

Planning a Linear Slot Air Diffuser specification?

Отправьте нам ваши габариты, условия монтажа, целевые показатели производительности и требуемую отделку поверхности.

Поговорите с нашей командой