English
Немецкий
Арабский язык
Французский
Индонезийский
Японский язык
Корейский
Японский
Португальский
Русский языкТекущий
Испанский язык
Тайский
Турецкий
Вьетнамский язык
Системы распределения воздуха в чистых помещениях
Испытательный порт прибора для воздуховода
A compact sealed probe access point for repeatable pressure, temperature and airflow measurements without drilling new holes in the duct wall.
- Reusable Probe Access
- Threaded Sealing Plug
- Low-Profile Duct Fitting
- Stainless Hygienic Body
Введение продукции
The instrument test port is a small stainless fitting installed through the duct wall at a defined measurement location. A threaded cap or tethered plug closes the opening between readings, while an elastomer grommet can seal around temporary probes. The flanged base spreads the load across thin sheet metal and is sealed to the external surface. Reusable ports prevent repeated drilling and foil-tape repairs during commissioning, filter checks and routine balancing.
Основные характеристики
The short smooth bore accepts pitot, pressure, temperature and air-quality probes.
A broad external flange stabilizes the fitting on thin rectangular or round duct walls.
Stainless construction tolerates repeated handling and cleanroom wipe-down chemicals.
Обеспокоенность клиентов продуктами
Measurement access must be repeatable and sealed so that routine testing does not leave open holes or adhesive patches in the air path.
Each balancing visit drills another hole through the duct wall.A permanent reusable port provides a single controlled probe location.
Foil tape lifts from a temporary hole and creates unnoticed leakage.A threaded cap and retained gasket form a mechanical closure between tests.
A probe scrapes a sharp raw sheet-metal edge.The smooth port bore protects instrument stems and operator hands.
Small fittings loosen when inserted through thin duct sheet.A wide flange and locked backing nut distribute load and resist rotation.
Типичные приложения
Differential-pressure measurementTemperature and humidity samplingPitot-tube airflow traversesFilter pressure checksCommissioning and periodic balancing
Технические параметры
Typical dimensions and material data for a reusable stainless duct instrument port are listed below.
| Основной материал | 304 stainless steel body with silicone or EPDM sealing element |
|---|---|
| Толщина панели | 1.0–2.0 mm flange and body wall |
| эффективная ширина | 8–16 mm clear probe opening |
| Максимальная длина | 50–100 mm installed stem length |
| Толщина линий стали | 1.0–2.0 mm stainless steel fitting wall |
| Плотность ядра | Approximately 7900–8000 kg/m³ stainless steel body |
| Теплопроводимость | Approximately 14–16 W/(m·K) for 304 stainless steel |
| Поверхностная отделка | Smooth passivated or brushed stainless steel with color-coded plug option |
| Объединенный тип | Threaded plug in flanged bulkhead body with backing nut and perimeter seal |
| Customization | Доступно в зависимости от предполагаемого применения и операционной среды. |
Доступные варианты
8, 10, 12 or 16 mm probe boreThreaded cap or tethered silicone plugColor-coded pressure-side identificationExtended stem for insulated duct walls
Planning a Instrument Test Port for Air Duct specification?
Отправьте нам ваши габариты, условия монтажа, целевые показатели производительности и требуемую отделку поверхности.
