Inglês
Alemão
Língua árabe
Francês
Língua indonésia
Japonês
Coreano
Língua malaia
Portuguêsatual
Língua russa
Espanhol
Tailandês
Língua turca
Vietnã
Filtros de ar e filtragem química
Filtro ULPA de baixa resistência
An extended-area U15 mini-pleat filter engineered to reduce pressure loss in high-recirculation cleanrooms while maintaining uniform airflow across the terminal face.
- Extended Media Area
- Optimized U15 Resistance
- Uniform Pleat Channels
- High-Recirculation Duty
Introdução do produto
The low-resistance ULPA filter balances U15-class filtration with the fan-energy demands of continuously recirculated semiconductor cleanrooms. A deeper mini-pleat pack provides increased effective area, and calibrated hot-melt separators keep each narrow air channel open at design flow. The pack is bonded into a rigid anodized-aluminium frame and protected by low-obstruction faceguards. Careful pleat density, pack depth and face velocity selection reduce resistance without thinning the filter structure or compromising clean terminal airflow.
Características-chave
Calibrated separator spacing prevents narrow pleat channels from pinching under operating pressure.
Low-obstruction protective grids shield the pack while preserving an open discharge area.
The rigid aluminium perimeter maintains a flat seal plane in large ceiling and FFU modules.
Preocupações do produto do cliente
Because recirculation fans operate continuously, even a modest unnecessary pressure loss across each ULPA terminal becomes a significant energy penalty.
U15 filters force FFU motors to operate near their upper speed range.Extended media area reduces local velocity and preserves more available fan pressure.
Aggressive pleat spacing creates blocked channels and inconsistent resistance.Controlled hot-melt bead geometry keeps a repeatable clear path between adjacent pleats.
A protective screen blocks too much of the discharge area.A thin open-grid faceguard protects the pack with limited obstruction.
Large ULPA panels bow and lose their perimeter seal.Reinforced aluminium extrusions and bonded corners maintain flatness across the terminal opening.
Aplicações típicas
High-recirculation semiconductor cleanroomsEnergy-conscious wafer fabrication baysUltra-clean flat-panel display facilitiesPrecision metrology clean spacesLarge fan filter unit arrays
Parâmetros técnicos
Typical construction ranges for an extended-area low-resistance ULPA filter are listed below.
| Material principal | Extended-area ultra-fine glass-microfibre or ePTFE ULPA media with optimized mini-pleat separators |
|---|---|
| Painel de espessura | 90–150 mm overall aluminium-frame depth |
| Largura efetiva | 305 - 610 mm Largura nominal da face |
| Comprimento máximo | Até 1220 mm de comprimento nominal do rosto |
| Aço enfrentando espessura | 0.4–0.5 mm low-obstruction coated-steel or stainless faceguard |
| Densidade Core | Approximately 28–45 kg/m³ equivalent extended-media-pack density |
| Condutividade térmica | Approximately 0.032–0.043 W/(m·K) for the dry ULPA media pack |
| Superfície acabado | Natural anodized aluminium with clean white or stainless open-grid faceguards |
| Tipo conjunto | Continuous EPDM gasket, polyurethane gel trough or knife-edge perimeter |
| Customização | Disponível com base na aplicação pretendida e no ambiente operacional. |
Opções disponíveis
U15 or U16 filtration classGlass-microfibre or ePTFE media90 mm or 150 mm extended-depth frameGasket, gel or knife-edge terminal seal
Planning a Low-Resistance ULPA Filter specification?
Envie-nos as suas dimensões, condições de instalação, metas de desempenho e acabamento de superfície necessário.
