Modular restricted access barrier system assembled around process equipment

Aliran Laminar dan Peralatan Pengekangan

Sistem Penghalang Akses Terhad Modular

A configurable barrier platform assembled from standard glazed, glove-access and service modules to fit new or existing aseptic equipment.

Configurable Modular Bays
New or Retrofit Installation
Interchangeable Glove Panels
Custom Machine Interfaces

Permintaan sebut harga Semak imbas produk

Pengenalan Produk

This modular RABS platform focuses on adaptable enclosure construction rather than one fixed open or closed airflow arrangement. Standard stainless frame bays accept clear fixed panels, glove doors, service doors, return sections and equipment cut-outs. The layout can be configured as an open or more enclosed barrier according to the process and cleanroom. Replaceable modules make later changes possible without rebuilding the entire enclosure, while the final airflow and access strategy remain specific to the installation.

Ciri-ciri Utama

Repeating frame bays adapt to different line lengths and equipment elevations.

Fixed glazing, glove panels and service doors can exchange positions within the grid.

Custom lower interfaces connect to irregular machine frames and conveyors.

Sectioned construction supports phased installation around existing equipment.

The platform can support open or closed airflow arrangements selected for the process.

Kebimbangan Produk Pelanggan

Existing process lines rarely match a fixed barrier geometry, and intervention points may change as equipment is upgraded.

A one-piece barrier cannot enter the existing production room.Sectioned modules assemble around the installed equipment.

Glove ports do not align after a machine change.Interchangeable glove-panel bays can be relocated within the modular grid.

Irregular conveyor penetrations remain open.Custom lower skirts and flexible seals close each equipment interface.

Future expansion requires replacing the full enclosure.Additional frame bays extend the barrier while existing modules are retained.

Permohonan yang biasa

RABS retrofit projectsPilot filling linesFlexible aseptic production cellsBarrier upgrades around legacy equipment

Parameter teknikal

Typical configurable construction ranges for a modular restricted access barrier system are listed below.

Bahan Teras	SUS304 or SUS316L modular frame with laminated safety-glass panels and interchangeable CSM glove modules
Ketebalan Panel	30-80 mm modular barrier and service sections
Lebar berkesan	1200-5000 mm protected equipment width
Panjang maksimum	Up to 30000 mm expandable barrier length
Keluli Menghadapi Ketebalan	1.2-2.0 mm stainless doors, skirts and utility panels
Ketumpatan teras	Approximately 2500 kg/m³ for laminated safety-glass panels
Kekonduksian Terma	0.8-1.0 W/(m·K) for laminated safety glass
Kemasan permukaan	Fine-brushed stainless modular frame with flush clear glazing
Jenis Bersatu	Bolted gasketed frame bays with replaceable glove, door, glazing and equipment-interface modules
Penyesuaian	Boleh didapati berdasarkan aplikasi yang dimaksudkan dan persekitaran operasi.

Pilihan yang boleh didapati

Open or closed airflow arrangementFixed, glove or service-door modulesStainless machine skirtsIntegrated lighting and monitoring rails

Planning a Modular Restricted Access Barrier System specification?

Hantarkan kepada kami dimensi anda, syarat pemasangan, sasaran prestasi dan kemasan permukaan yang diperlukan.

Berbincang dengan pasukan kami