Anglais
Allemand
Arabe
FrançaisCurrent
Indonésien
Japonais
Coréen
Le malais
Le portugais
russe
espagnol
Thaïlandais
Le turc
Le vietnamien
Équipement d'écoulement et de confinement laminaires
Système de barrière d'accès modulaire par
A configurable barrier platform assembled from standard glazed, glove-access and service modules to fit new or existing aseptic equipment.
- Configurable Modular Bays
- New or Retrofit Installation
- Interchangeable Glove Panels
- Custom Machine Interfaces
Introduction de produit
This modular RABS platform focuses on adaptable enclosure construction rather than one fixed open or closed airflow arrangement. Standard stainless frame bays accept clear fixed panels, glove doors, service doors, return sections and equipment cut-outs. The layout can be configured as an open or more enclosed barrier according to the process and cleanroom. Replaceable modules make later changes possible without rebuilding the entire enclosure, while the final airflow and access strategy remain specific to the installation.
Key Features
Fixed glazing, glove panels and service doors can exchange positions within the grid.
Custom lower interfaces connect to irregular machine frames and conveyors.
Sectioned construction supports phased installation around existing equipment.
The platform can support open or closed airflow arrangements selected for the process.
Préoccupations du client produit
Existing process lines rarely match a fixed barrier geometry, and intervention points may change as equipment is upgraded.
A one-piece barrier cannot enter the existing production room.Sectioned modules assemble around the installed equipment.
Glove ports do not align after a machine change.Interchangeable glove-panel bays can be relocated within the modular grid.
Irregular conveyor penetrations remain open.Custom lower skirts and flexible seals close each equipment interface.
Future expansion requires replacing the full enclosure.Additional frame bays extend the barrier while existing modules are retained.
Les applications typiques
RABS retrofit projectsPilot filling linesFlexible aseptic production cellsBarrier upgrades around legacy equipment
Paramètres techniques
Typical configurable construction ranges for a modular restricted access barrier system are listed below.
| Matériaux de base | SUS304 or SUS316L modular frame with laminated safety-glass panels and interchangeable CSM glove modules |
|---|---|
| Panneau épaisseur | 30-80 mm modular barrier and service sections |
| Largeur effective | 1200-5000 mm protected equipment width |
| Longueur maximale | Up to 30000 mm expandable barrier length |
| Acier face épaisseur | 1.2-2.0 mm stainless doors, skirts and utility panels |
| Densité Core | Approximately 2500 kg/m³ for laminated safety-glass panels |
| Conductivité thermique | 0.8-1.0 W/(m·K) for laminated safety glass |
| surface finie | Fine-brushed stainless modular frame with flush clear glazing |
| Type joint | Bolted gasketed frame bays with replaceable glove, door, glazing and equipment-interface modules |
| Customisation | Disponible en fonction de l'application prévue et de l'environnement d'exploitation. |
Options disponibles
Open or closed airflow arrangementFixed, glove or service-door modulesStainless machine skirtsIntegrated lighting and monitoring rails
Planning a Modular Restricted Access Barrier System specification?
Envoyez-nous vos dimensions, conditions d'installation, objectifs de performance et finition de surface requise.
