Isolation transformer in a light-grey enclosed cabinet with terminal cover

Cleanroom Lighting dan Peralatan Listrik

Isolasi Transformator

A dry-type transformer that provides galvanic separation, voltage adaptation and optional electrostatic shielding for sensitive cleanroom loads.

Galvanically Isolated Windings
Low-Noise Laminated Core
Electrostatic Shield Option
Enclosed Finger-Safe Terminals

Permintaan untuk kutipan Browse Produk

Perkenalan produk

The isolation transformer uses separate primary and secondary windings on a laminated magnetic core. Encapsulated or varnish-impregnated coils resist moisture and vibration, and an optional copper electrostatic shield is bonded to earth between windings to attenuate common-mode noise. The assembly is housed in a non-ventilated or guarded enclosure with clearly separated input and output terminals.

Fitur utama:

Physically separate windings prevent a direct conductive path between input and output.

Encapsulated coils support consistent insulation and lower audible vibration.

An interwinding shield diverts coupled high-frequency noise to protective earth.

Finger-safe terminal blocks organize primary taps and secondary connections.

Rubber isolation mounts reduce mechanical hum transmitted to the floor or wall.

Kekhawatiran produk pelanggan

Sensitive equipment can be affected by ground noise, voltage mismatch and transformer hum even when the nominal supply remains available.

Common-mode electrical noise enters instrument reference circuits.Galvanic separation and an optional grounded shield reduce capacitive noise transfer.

A transformer enclosure transmits audible hum into a quiet laboratory.A welded core, coil impregnation and resilient mounting pads limit vibration.

Exposed terminal studs create accidental-contact risk.A guarded wiring compartment uses labeled finger-safe connectors.

Dust enters an open ventilated enclosure near a clean process.An encapsulated non-ventilated configuration closes the core and coil from room air.

Aplikasi yang Tipis

Sensitive analytical instrumentsCleanroom control powerMedical-device test benchesNoise-sensitive monitoring systems

Parameter teknis

Typical configurable construction ranges for an isolation transformer are listed below.

Bahan inti	Grain-oriented silicon-steel core with separate copper windings, insulation system and optional copper electrostatic shield
Ketebalan Panel (Panel Thickness)	200-650 mm enclosed transformer depth
Efektif lebar	250-900 mm cabinet width
Panjang maksimum	Up to 1200 mm overall enclosure height
Baja menghadap ketebalan	1.0-2.0 mm powder-coated steel or stainless enclosure
Kepadatan inti (core density)	Approximately 7600-7700 kg/m³ for laminated electrical steel core material
Konduktivitas Termal (Thermal Conductivity)	20-30 W/(m·K) for laminated silicon steel across the core assembly
Permukaan selesai	Light-grey or white powder-coated enclosure with copper earth and terminal markings
Jenis Bersama	Bolted or welded core-and-coil assembly on resilient mounts with segregated terminal compartment
Customization (Kustomisasi)	Tersedia berdasarkan aplikasi yang dimaksudkan dan lingkungan operasi.

Pilihan yang tersedia

Single- or three-phase designEncapsulated or ventilated dry typeElectrostatic shieldInput and output voltage tap selection

Planning a Isolation Transformer specification?

Kirimkan kami dimensi Anda, kondisi instalasi, target kinerja dan permukaan akhir yang diperlukan.

Bicaralah dengan tim kami