Isolation transformer in a light-grey enclosed cabinet with terminal cover

클린룸 조명 및 전기 장비

격리 변압기

A dry-type transformer that provides galvanic separation, voltage adaptation and optional electrostatic shielding for sensitive cleanroom loads.

Galvanically Isolated Windings
Low-Noise Laminated Core
Electrostatic Shield Option
Enclosed Finger-Safe Terminals

견적 요청 제품 찾아보기

상품 소개

The isolation transformer uses separate primary and secondary windings on a laminated magnetic core. Encapsulated or varnish-impregnated coils resist moisture and vibration, and an optional copper electrostatic shield is bonded to earth between windings to attenuate common-mode noise. The assembly is housed in a non-ventilated or guarded enclosure with clearly separated input and output terminals.

주요 기능

Physically separate windings prevent a direct conductive path between input and output.

Encapsulated coils support consistent insulation and lower audible vibration.

An interwinding shield diverts coupled high-frequency noise to protective earth.

Finger-safe terminal blocks organize primary taps and secondary connections.

Rubber isolation mounts reduce mechanical hum transmitted to the floor or wall.

고객 제품 관심사

Sensitive equipment can be affected by ground noise, voltage mismatch and transformer hum even when the nominal supply remains available.

Common-mode electrical noise enters instrument reference circuits.Galvanic separation and an optional grounded shield reduce capacitive noise transfer.

A transformer enclosure transmits audible hum into a quiet laboratory.A welded core, coil impregnation and resilient mounting pads limit vibration.

Exposed terminal studs create accidental-contact risk.A guarded wiring compartment uses labeled finger-safe connectors.

Dust enters an open ventilated enclosure near a clean process.An encapsulated non-ventilated configuration closes the core and coil from room air.

일반적인 응용 프로그램

Sensitive analytical instrumentsCleanroom control powerMedical-device test benchesNoise-sensitive monitoring systems

기술 매개변수

Typical configurable construction ranges for an isolation transformer are listed below.

핵심 재료	Grain-oriented silicon-steel core with separate copper windings, insulation system and optional copper electrostatic shield
패널 두께	200-650 mm enclosed transformer depth
유효 폭	250-900 mm cabinet width
최대 길이	Up to 1200 mm overall enclosure height
강철 면면 두께	1.0-2.0 mm powder-coated steel or stainless enclosure
코어 밀도	Approximately 7600-7700 kg/m³ for laminated electrical steel core material
열전도도 (Thermal Conductivity)	20-30 W/(m·K) for laminated silicon steel across the core assembly
표면 마무리	Light-grey or white powder-coated enclosure with copper earth and terminal markings
접합 유형	Bolted or welded core-and-coil assembly on resilient mounts with segregated terminal compartment
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

사용 가능한 옵션

Single- or three-phase designEncapsulated or ventilated dry typeElectrostatic shieldInput and output voltage tap selection

Planning a Isolation Transformer specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.